Phosphorous acid, model structure

The solids analysis described above can be taken to yet another level by correlating the color measurement to chemical properties. An excellent model system is vanadium pyrophosphate (VPO), which is a well-known catalyst for butane oxidation to maleic anhydride. During the synthesis of the catalyst precursor, solid V2O5 particles are dispersed in a mixture of benzyl alcohol and i-butanol. In this slurry phase, the vanadium is partly reduced. Addition of phosphoric acid leads to a further reduction and the formation of the VPO structure. With a diffuse reflectance (DR) UV-vis probe by Fiberguide Ind., the surface of the suspended solid particles could be monitored during this slurry reaction. Four points can be noted from Figure 4.4 ... 

Since its discovery by Pasteur in 1853,5 classical resolution by selective crystallization of diastereo-isomers, despite wide and frequent use, remains to a large degree a method of trial and error. Various attempts to rationalize classical resolutions and predict a successful combination of race-mate and resolving agent by computational approaches so far have not been crowned with remarkable success.6 Even when the crystal structures of both diastereoisomeric salts are known, molecular modeling calculations do not provide a basis for a reliable prediction. Only recently has some progress been made in the calculation of the relative thermodynamic stability of ephedrine-cyclic phosphoric acid 4 diastereoisomers,7 a diastereoisomeric salt frequently used as a model system (vide infra). 

Scheme 3 contains several of the fundamental structures with penta-valent phosphorus, among them phosphorane itself, PH6 (21), and pentahydroxyphosphorane, P(OH)6 (26). The latter is the hydrate of phosphoric acid H3P04+H20 - P(OH)5. A hydrate of methylphos-phonic acid (CH3)(HO)4P (29), is also included as a model for its esters. Mono- and di-ionized forms, (27), (28), (30), are also given, since their stabilities in various isomeric forms provide important data concerning the role of intermediate oxyphosphoranes in the chemistry of phosphoric acid and its derivatives. A model compound of the 1,2-oxaphospholene ring (31), is provided, since this system, in the form of several derivatives, will be discussed extensively in Section VIII. 

The same type of calculations have been performed using experimental X-ray structure factors on crystalline phosphoric acid, 7V-acetyl-a,P-dehydrophenyl-alamine methylamide, and N-acetyl-1 -tryptophan methylamide by Souhassou [60] on urea, 9-methyladenosine, and imidazole by Stewart [32] and on 1-alanine [61] and annulene derivatives [62] by Destro and co-workers. The latter authors collected their X-ray data at 16 K [63]. Stewart [32] showed that the positions of the (3, -1) critical points from the promolecule are very close to those of the multipole electron density, but that large differences appear in comparing the density, the Laplacian maps, and the ellipticities at the critical points. Destro et al. [67] showed that the results obtained may be slightly dependent on the refinement model. 

Kinoshita has also shown that ORR data for supported catalysts in hot, concentrated H3PO4 (180 °C, 97-98% acid) reported in three different studies were also fit by this model. Since the physical basis for the crystallite size effect in sulfuric acid is anion adsorption, it would be a considerable reach to suggest that the same physical basis applies to this size effect, i.e., structure-sensitive anion adsorption. There are, nonetheless, indications that this is the case. Anion adsorption in dilute phosphoric [43] has a very similar structure sensitivity as sulfate adsorption, i.e., strongest adsorption on the (111) face, and on poly-Pt anion adsorption and/or neutral molecule adsorption in dilute phosphoric has a strongly inhibiting effect on the kinetics of the ORR [43]. Sattler and Ross [16] report a similar crystallite size dependence of the ORR on supported Pt in dilute phosphoric acid at ambient temperature as that found in hot, concentrated acid with the same catalysts. But it is unclear whether similar adsorption chemistry would exist in the extreme conditions of hot, concentrated phosphoric acid. 

The proposed model implies that the crystallographic structure (symmetry and cation—cation distances) of the oxide substrate determines whether order can be achieved in the case of a particular phosphoric acid ester SAM. Studying single-crystal metal oxide surfaces with different Miller indices will be used in the future to test this assumption. 

In the Friedel-Crafts realm, Lou and coworkers reported on the activity of Mg-phosphoric acid-based binary catalyst in the alkylation of free phenols via Michael addition of p,y-unsaturated a-ketoesters 25 [41], Despite the real structure of the binary organometallic catalytic species is still unknown, excellent levels of chemical and optical outcomes were achieved in the titled process (Scheme 5.24). To be mentioned that neither the BA nor MgF alone could promote the model reaction at any extents, proving the formation of a concertedly activated catalytic aggregate between the two acids. 

---