Phosphated gels

Acetoin dehydrogenase [from beef liver acetoin NAD oxidoreductase] [9028-49-3] Mr 76000, [EC 1.1.1.5]. Purified via the acetone cake then Ca-phosphate gel filtration (unabsorbed), lyophilised and then fractionated through a DEAE-22 cellulose column. The Km for diacetyl in 40pM and for... 

The setting reaction of dental silicate cement was not understood until 1970. An early opinion, that of Steenbock (quoted by Voelker, 1916a,b), was that setting was due to the formation of calcium and aluminium phosphates. Later, Ray (1934) attributed setting to the gelation of silicic acid, and this became the received opinion (Skinner Phillips, 1960). Wilson Batchelor (1968) disagreed and concluded from a study of the acid solubility that the dental silicate cement matrix could not be composed of silica gel but instead could be a silico-phosphate gel. However, infrared spectroscopy failed to detect the presence of P-O-Si and P-O-P bonds (Wilson Mesley, 1968). 

The nature of the setting reaction was finally elucidated by Wilson et al. (1970a), who established that formation of an aluminium phosphate gel was responsible although siliceous gel was also formed it merely coated the partly reacted glass particles. 

The following account is based mainly on the studies of Wilson and coworkers, with some re-interpretation of experimental data. The composition of the cement used is given in Table 6.9. In brief, the reaction takes place in several overlapping stages extraction of ions from the glass, migration of cations into the aqueous phase, precipitation of insoluble salts as pH increases, leading to formation of an aluminium phosphate gel. 

In the subsequent hardening phase, precipitation and hydration continue. The set cement consists, essentially, of partly-reacted glass particles embedded in an aluminium phosphate gel. The morphology of the filler particles is one where a glass core is sheathed by silica gel. 

Macmillan and coworkers51 105 106 purified pectinesterase produced by Clostridium multifermentans by using practically all of the available methods and materials (calcium phosphate gel, DEAE-cellulose, DEAE-, QEAE-, CM-, and SE-Sephadex, Sephadexes G-75, G-100, G-150, and G-200, Sepharose 4B, and zonal centrifugation). However, they could not separate pectinesterase from exo-pectate lyase, and, hence, they postulated that either (a) a complex of the two enzymes having an apparent molecular weight of 400,000 exists, or (b) the two enzymes are identical in their molecular species. On the basis of the mode of action of this pectinesterase in comparison with that of those from tomatoes and from Fusarium ox-ysporum, the existence of a complex of pectinesterase and exopectate lyase in Clostridium multifermentans appears to be the more probable. 

Addition of a soluble Zr(IV) salt to phosphoric acid results in the precipitation of a gelatinous amorphous solid. The stoichiometric crystalline zirconium phosphate can be prepared by refluxing zirconium phosphate-gel in concentrated phosphoric acid [5]. The procedures for synthesis of zirconium phosphate have been described in detail elsewhere [6]. 

Eigel, W. N. and Randolph, H. E. 1974. Preparation of whole 7-casein by treatment with calcium phosphate gel. J. Dairy Sci. 57, 1444-1447. 

Adsorptive Properties. Under certain conditions of pH and low ionic strength, certain proteins will be adsorbed by various substances. Calcium phosphate gel and alumina Cy gel, for example, are frequently used to adsorb specific proteins from heterogeneous mixtures. The adsorbed proteins can frequently be released from the insoluble support either by altering the pH or increasing the ionic strength. Thus, purification can be obtained by removing either the extraneous unwanted proteins or the desired protein with the gel. 

The rate of exothermic heat production and hence dissolution rate of oxides should be sufficiently slow to allow the phosphate gel to crystallize slowly into a well-ordered crystal lattice without interruption, and grow into a monolithic ceramic. 

The final cement is an opaque solid that consists of excess zinc oxide coated and bonded by possibly aluminum phosphate and zinc phosphate gels. The cement is porous and permeable to dyes [10]. 

---