Partial pressure equation

As the equilibrium constant K is determined from the equUibrium partial pressures [Equation (10.21)] it is given by... 

Instead of c, the partial pressure of species 1 (or the total pressure if only one species is present) is generally measured in experiments and is used in equation (94). Since the proportionality factor between partial pressures and depends only on T, this factor may be absorbed into k, and equations (92) and (94) remain valid when concentrations are replaced by partial pressures. When written in terms of partial pressures, equation (94) is the Langmuir adsorption isotherm. 

Step 1 Although there are no mass variables in our partial pressure equations, we do know that we can convert mass to moles using molar masses. 

Fugacity coefficients are important in considering the boiling of hydrothermal fluids, and have been approached from the virial equation as well as from numerous modifications of the van der Waals equation, the best known of these being the (modified) Redlich-Kwong equation. However, they are of minor importance in most environmental situations, and are routinely assumed to be 1.0, so that the activity of gaseous solution components is equal to the partial pressure (Equation (3.14)). 

Since the oxygen pressures used were orders of magnitude higher than the decomposition pressure of CoO the variation of the parabolic rate constant kp with oxygen partial pressures, Equation (4.17),... 

According to Dalton s law of partial pressures (Equation 10.12), the total pressure in the vessel is the sum of the partial pressures ... 

The partial pressures (Equation 5.23) can also be expressed in terms of the total pressure by multiplying the nnmerator and denominator of Equation 5.23 by % ... 

With respect to the relationship between conductivity ((7) and gas partial pressure. Equation (1) has been found to apply. 

Terms other than permeability (Equation 12.6), such as permeant transmission rate, permeance, and thickness normalized flow, can be used to describe the steady-state permeation of molecules through the polymer films [2]. Permeant transmission rate is the amount of permeant passing through a plane of unit area normal to the direction of the flow during unit time (Equation 12.8). The term permeance is used when differences in partial pressure between both sides of the material are also taken into account (Equation 12.9), whereas thickness normalized flow considers material thickness but not difference in partial pressure (Equation 12.10). 

Thus, the free energy and oxygen partial pressure equations for the FeO phase (wustite) are... 

Thus, the reaction oxygen partial pressure equations become dependent on the free energy of formation of the FeO - Fea04 and FesOi - FeO systems. Hence,... 

The chemical formula of the ions in the mass spectrum is obtained from the mass of the ions and their isotopic distribution. The next step is the assignment of the observed ions to their neutral precursors in the equilibrium vapour and the calculation of the vapour species, partial pressures. Equations [1] to [3] reveal a set of tasks which have to be completed if calculated partial pressure values are to be reliable ... 

---