Nitrogen storage component

FIGURE 32.5 Representative load-displacement curve obtained from bearing surfaces of three acetabular components irradiated and stored in either nitrogen or air. After 10 years storage in nitrogen, the load-displacement curve is nearly identical to that obtained immediately poststerilization in nitrogen. The component irradiated and stored in air is substantially degraded after only 5 years. The base resin was GUR 1020 compression molded in all cases. Adapted from Edidin et al. [10]. 

Fig. 5. Equipment foi surface treating plastic components. Parts ate loaded into one of the two lower chambers which is then evacuated to remove most of the air. This chamber is then flooded with a dilute mixture of fluorine and nitrogen which is made and stored in the upper chamber. After the treatment is completed, the fluorine mixture is pumped back up to the upper chamber for storage and the lower chamber repeatedly flooded with air and evacuated to remove any traces of fluorine gas. Two treatment chambers are cycled between the loading/unloading operation and the treatment step to increase equipment output. The fluorine—nitrogen blend may be used several times before by-products from the treatment process begin to interfere. AH waste...

Repeated attempts to obtain the band at 1030 cm 1 in spectra of the respective solids of various compositions did not furnish the desired result. Nevertheless, the band was observed in IR transmission spectra of gaseous components that separated from molten K2NbF7 and were collected in a standard gas phase cell with Csl windows appropriate for IR measurements. Fig. 85 presents the structure of the band and exact wave numbers of its components. Storage of the gas in the cell for several days resulted in a yellow deposit on the windows due to oxidation and subsequent separation of iodine. Analysis of available reported data [364 - 367] enables to assign the band observed at -1030 cm 1 to vibrations of OF radicals. It should be emphasized that a single mode was observed for OF in the argon matrix while in the case of nitrogen, two modes were indicated [367]. 

About 100 gal of process wastewater is typically generated from 1 t of coke produced.15 These wastewaters from byproduct coke making contain high levels of oil and grease, ammonia nitrogen, sulfides, cyanides, thiocyanates, phenols, benzenes, toluene, xylene, other aromatic volatile components, and polynuclear aromatic compounds. They may also contain toxic metals such as antimony, arsenic, selenium, and zinc. Water-to-air transfer of pollutants may take place due to the escape of volatile pollutants from open equalization and storage tanks and other wastewater treatment systems in the plant. 

---