Nitrogen chloride, hydrolysis

Hydrolysis. Heating 1,2-dichloroethane with excess water at 60°C in a nitrogen atmosphere produces some hydrogen chloride. The rate of evolution is dependent on the temperature and volume of the aqueous phase. Hydrolysis at 160—175°C and 1.5 MPa (15 atm) in the presence of an acid... 

Sulfonamides (R2NSO2R ) are prepared from an amine and sulfonyl chloride in the presence of pyridine or aqueous base. The sulfonamide is one of the most stable nitrogen protective groups. Arylsulfonamides are stable to alkaline hydrolysis, and to catalytic reduction they are cleaved by Na/NH3, Na/butanol, sodium naphthalenide, or sodium anthracenide, and by refluxing in acid (48% HBr/cat. phenol). Sulfonamides of less basic amines such as pyrroles and indoles are much easier to cleave than are those of the more basic alkyl amines. In fact, sulfonamides of the less basic amines (pyrroles, indoles, and imidazoles) can be cleaved by basic hydrolysis, which is almost impossible for the alkyl amines. Because of the inherent differences between the aromatic — NH group and simple aliphatic amines, the protection of these compounds (pyrroles, indoles, and imidazoles) will be described in a separate section. One appealing proj>erty of sulfonamides is that the derivatives are more crystalline than amides or carbamates. 

The acylation of enamino ketones can take place on oxygen or on carbon. While reaction at nitrogen is a possibility, the N-acylated products are themselves acylating agents, and further reaction normally takes place. The first reported acylation of enamino ketones (72) was that of 129, prepared by acylation of the enamine (113), which was shown to have undergone O acylation because on mild hydrolysis the enol ester (130) could be isolated. A similar reaction took place with other aliphatic acid chlorides (80) and with dibasic acid chlorides [e.g., with succinyl chloride to give 118 above]. 

Since the ring nitrogen at 3 is now comparable in reactivity to the amine at 4, acylation with one equivalent of 88 gives a mixture of products. The desired product, sulfaisodimidine (109), can be obtained by acylation with an excess of the sulfonyl chloride (140) followed by alkaline hydrolysis. The rate of saponification of the sulfonamide group attached to the ring nitrogen is sufficiently greater to cause it to be lost selectively. 

Conversion of Amides into Carboxylic Acids Hydrolysis Amides undergo hydrolysis to yield carboxylic acids plus ammonia or an amine on heating in either aqueous acid or aqueous base. The conditions required for amide hydrolysis are more severe than those required for the hydrolysis of add chlorides or esters but the mechanisms are similar. Acidic hydrolysis reaction occurs by nucleophilic addition of water to the protonated amide, followed by transfer of a proton from oxygen to nitrogen to make the nitrogen a better leaving group and subsequent elimination. The steps are reversible, with the equilibrium shifted toward product by protonation of NH3 in the final step. 

Merck s thienamycin synthesis commences with mono (V-silylation of dibenzyl aspartate (13, Scheme 2), the bis(benzyl) ester of aspartic acid (12). Thus, treatment of a cooled (0°C) solution of 13 in ether with trimethylsilyl chloride and triethylamine, followed by filtration to remove the triethylamine hydrochloride by-product, provides 11. When 11 is exposed to the action of one equivalent of tm-butylmagnesium chloride, the active hydrogen attached to nitrogen is removed, and the resultant anion spontaneously condenses with the electrophilic ester carbonyl four atoms away. After hydrolysis of the reaction mixture with 2 n HC1 saturated with ammonium chloride, enantiomerically pure azetidinone ester 10 is formed in 65-70% yield from 13. Although it is conceivable that... 

B. Reactions.—(/) Nucleophilic Attack at Phosphorus. A reinvestigation of the reaction between phosphorus trichloride and t-butylbenzene in the presence of aluminium chloride has shown that the product after hydrolysis is the substituted phosphinic acid (11), and not the expected phosphonic acid (12). Bis(A-alkylamino)phosphines have been reported to attack chlorodiphenyl phosphine with nitrogen, in the presence of a base, to give bis-(A-alkyl-A-diphenylphosphinoamino)phenylphosphines (13). In (13), the terminal phosphorus atoms are more reactive than the central one towards sulphur and towards alkyl halides. 

Mixing trichlorosilane, acetonitrile and diphenylsulphoxide, carried out at 10°C, detonated. This accident was put down to the exothermic addition reaction of the silicon-hydrogen bond on the carbon-nitrogen triple bond of nitrile. Other interpretations are possible for instance, the effect of traces of hydrogen chloride formed by the hydrolysis of chlorosilane on acetonitrile. 

The compounds referred to as azolides are heterocyclic amides in which the amide nitrogen is part of an azole ring, such as imidazole, pyrazole, triazole, tetrazole, benzimidazole, benzotriazole, and their substituted derivatives. In contrast to normal amides, most of which show particularly low reactivities in such nucleophilic reactions as hydrolysis, alcoholysis, aminolysis, etc., the azolides are characterized by high reactivities in reactions with nucleophiles within the carbonyl group placing these compounds at about the same reactivity level as the corresponding acid chlorides or anhydrides. 11... 

---