Multiple part problems, significant

A low temperature of approach for the network reduces utihties but raises heat-transfer area requirements. Research has shown that for most of the pubhshed problems, utility costs are normally more important than annualized capital costs. For this reason, AI is chosen eady in the network design as part of the first tier of the solution. The temperature of approach, AI, for the network is not necessarily the same as the minimum temperature of approach, AT that should be used for individual exchangers. This difference is significant for industrial problems in which multiple shells may be necessary to exchange the heat requited for a given match (5). The economic choice for AT depends on whether the process environment is heater- or refrigeration-dependent and on the shape of the composite curves, ie, whether approximately parallel or severely pinched. In cmde-oil units, the range of AI is usually 10—20°C. By definition, AT A AT. The best relative value of these temperature differences depends on the particular problem under study. 

If a problem has both addition or subtraction and multiplication or division, the part that is done first must have its significant digits noted before the next operation is performed, because the rules are different for determining which digits are retained. 

---