Multiphase mixtures

For a heterogeneous or multiphase mixture, separation usually can be achieved by phase separation. Such phase separation should be carried out before any homogeneous separation. Phase separation tends to be easier and should be done first. 

The wedge restriction has no critical surface dimensions or sharp edges and tends to retain accuracy despite visible corrosive or erosive wear. It is commonly appHed to high viscosity Hquids, slurries, and hot multiphase mixtures. A similar device is also available using a cone, positioned so that its large diameter is upstream, mounted on the meter centerline. 

If a heterogeneous or multiphase mixture needs to be separated, then separation can be done physically by exploiting... 

The primary product from Fischer-Tropsch synthesis is a complex multiphase mixture of hydrocarbons, oxygenates, and water. The composition of this mixture is dependent on the Fischer-Tropsch technology and considerable variation in carbon number distribution, as well as the relative abundance of different compound classes is possible. The primary Fischer-Tropsch product has to be refined to produce final products, and in this respect, it is comparable to crude oil. The primary product from Fischer-Tropsch synthesis can therefore be seen as a synthetic crude oil (syncrude). There are nevertheless significant differences between crude oil and Fischer-Tropsch syncrude, thus requiring a different refining approach.1... 

In eq 51, the first term represents a convection term, and the second comes from a mass flux of water that can be broken down as flow due to capillary phenomena and flow due to interfacial drag between the phases. The velocity of the mixture is basically determined from Darcy s law using the properties of the mixture. The appearance of the mixture velocity is a big difference between this approach and the others, and it could be a reason the permeability is higher for simulations based on the multiphase mixture model. 

The overall gain of the multiphase mixture model approach above is that the two-phase flow is still considered, but the simulations have only to solve pseudo-one-phase equations. Problems can arise if the equations are not averaged correctly. Also, the pseudo-one-phase treatment may not allow for pore-size distribution and mixed wettability effects to be considered. Furthermore, the multiphase mixture model predicts much lower saturations than those of Natarajan and Nguyen - and Weber and Newman even though the limiting current densities are comparable. However, without good experimental data on relative permeabilities and the like, one cannot say which approach is more valid. 

---