Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Mold gate pinpoint

Diaphragms or ring gates can be used for molding parts where concentricity is important such as cylindrical parts or parts where weld lines can not be tolerated. Pinpoint gates should not be used unless parts (small) are injected rapidly. Tunnel gating can also be used in such cases. Gate location should be at one of the points listed in Table 6.26. [Pg.222]

Sometimes referred to as pinpoint gate. A small opening between the runner and cavity in an injection or transfer mold. [Pg.2258]

Center Similar to pinpoint but is larger also gate extension is left in molded part... [Pg.321]

FIGURE 1.34 Pinpoint gate without separation from the molded part, s = 0.5 to 2.0 mm... [Pg.52]

FIGURE 1.39 Three-plate mold with a tear- off pinpoint gate... [Pg.55]

See other pages where Mold gate pinpoint is mentioned: [Pg.369]    [Pg.369]    [Pg.167]    [Pg.169]    [Pg.32]    [Pg.34]    [Pg.452]    [Pg.722]    [Pg.836]    [Pg.228]    [Pg.233]    [Pg.235]    [Pg.336]    [Pg.538]    [Pg.627]    [Pg.51]    [Pg.400]    [Pg.171]    [Pg.167]    [Pg.169]    [Pg.104]    [Pg.119]   
See also in sourсe #XX -- [ Pg.369 ]



SEARCH



Pinpoint gates

Pinpointing

© 2024 chempedia.info