Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Moisture machine direction control

Material control. Because dried material flows directly into the machine, there is no need to be concerned about moisture regain after drying. [Pg.560]

Measurement of the moisture content of sinter feed with feedback to direct water additions at various mixing points is thus an essential part of good sinter machine control. Various devices are used for online moisture measurement, including infrared devices and electrical conductivity probes. The latter are most common and can simply be two trailing electrodes in contact with the feed material on a conveyor belt. These devices are not highly reliable and need careful and regular calibration since they are affected by the presence of soluble salts, which can change the electrical conductivity of the free interstitial water in the sinter bed. [Pg.52]


See other pages where Moisture machine direction control is mentioned: [Pg.596]    [Pg.204]    [Pg.341]    [Pg.342]    [Pg.379]    [Pg.553]    [Pg.213]    [Pg.539]    [Pg.570]    [Pg.217]    [Pg.169]    [Pg.217]    [Pg.517]    [Pg.197]   
See also in sourсe #XX -- [ Pg.412 ]




SEARCH



Control direct

Machine controller

Machine direction control

© 2024 chempedia.info