Metal CO complexes

Two different metal-C02 complex intermediates have been proposed for the production of CO-metallocarboxylates and metal formates. The difference between the two species is based on the site of protonation, at the carbon atom in metallocarboxylates and at one of the oxygen atoms in metal formates. Carbon-protonation has not been observed experimentally, while oxygen-protonation is well known [9]. Isomerization can occur between metallocarboxylates and metal formates, and loss of a hydroxide group from the metal formate species yields the M-CO complex. Similarly, the direct reaction of metal complexes with free, dissolved C02 has also been described. In this mechanism, the metal complex reacts with an oxide acceptor, such as C02, generating the metal-CO complex and C032- [9],... 

Shorter pulse excitation has been shown to be more efficient for producing a molecular ion for the case of C6o [20,21], Ceo was ionized by pulses from 5 ps to 9 fs. The shortest pulse of 9 fs has been shown to produce Cg(j" (z = 1) without fragmentation. Metal CO complexes also showed smaller yields of fragmentation by shorter pulase excitation in two different pulse widths of 50 and 110 fs [16]. The same tendency has been observed in ionization of 2,3-dimethyl-l,3-butadiene. The relative molecular ion intensity increased as the decrease in the pulse width in a range from 1000 to 15 fs [4,13],... 

Sequences such as the above allow the formulation of rate laws but do not reveal molecular details such as the nature of the transition states involved. Molecular orbital analyses can help, as in Ref. 270 it is expected, for example, that increased strength of the metal—CO bond means decreased C=0 bond strength, which should facilitate process XVIII-55. The complexity of the situation is indicated in Fig. XVIII-24, however, which shows catalytic activity to go through a maximum with increasing heat of chemisorption of CO. Temperature-programmed reaction studies show the presence of more than one kind of site [99,1(K),283], and ESDIAD data show both the location and the orientation of adsorbed CO (on Pt) to vary with coverage [284]. 

The red tetrathiomolybdate ion appears to be a principal participant in the biological Cu—Mo antagonism and is reactive toward other transition-metal ions to produce a wide variety of heteronuclear transition-metal sulfide complexes and clusters (13,14). For example, tetrathiomolybdate serves as a bidentate ligand for Co, forming Co(MoSTetrathiomolybdates and their mixed metal complexes are of interest as catalyst precursors for the hydrotreating of petroleum (qv) (15) and the hydroHquefaction of coal (see Coal conversion processes) (16). The intermediate forms MoOS Mo02S 2> MoO S have also been prepared (17). 

Studies on metal-pyrazole complexes in solution are few. The enthalpy and entropy of association of Co(II), Ni(II), Cu(II) and Zn(II) with pyrazole in aqueous solution have been determined by direct calorimetry (81MI40406). The nature of the nitrogen atom, pyridinic or pyrrolic, involved in the coordination with the metal cannot be determined from the available thermodynamic data. However, other experiments in solution (Section 4.04.1.3.3(i)) prove conclusively that only the N-2 atom has coordinating capabilities. 

The nature of the bonding, particularly in CO, has excited much attention because of the unusual coordination number (1) and oxidation state (-f2) of carbon it is discussed on p. 926 in connection with the formation of metal-carbonyl complexes. 

The complex CUCN.NH3 provides an unusual example of CN aeting as a bridging ligand at C, a mode which is common in p,-CO complexes (p. 928) indeed, the complex is unique in featuring tridentate CN groups which link the metal atoms into plane nets via the Cu... 

Figure 13.24 Structure of the cubane-like mixed metal-metal cluster complex [Sb4- Co(CO)3l4].

By contrast, reaction of XeFi with the iridium carbonyl complex cation [Ir(CO)3(PEt3)2] in CH2CI2 results in addition across one of the Ir-CO bonds to give the first example of a metal fluoroacyl complex ... 

On refluxing a toluene solution of benzoisotellurazole and Fe3(CO)L2, cleavage of the Te—N bond occurs, resulting in formation of the metal chelate complex 11 whose structure was determined by X-ray (97MI1). 

The first reaction pathway for the in situ formation of a metal-carbene complex in an imidazolium ionic liquid is based on the well loiown, relatively high acidity of the H atom in the 2-position of the imidazolium ion [29]. This can be removed (by basic ligands of the metal complex, for example) to form a metal-carbene complex (see Scheme 5.2-2, route a)). Xiao and co-workers demonstrated that a Pd imida-zolylidene complex was formed when Pd(OAc)2 was heated in the presence of [BMIMjBr [30]. The isolated Pd carbene complex was found to be active and stable in Heck coupling reactions (for more details see Section 5.2.4.4). Welton et al. were later able to characterize an isolated Pd-carbene complex obtained in this way by X-ray spectroscopy [31]. The reaction pathway to the complex is displayed in Scheme 5.2-3. 

Another means of in situ metal-carbene complex formation in an ionic liquid is the direct oxidative addition of the imidazolium cation to a metal center in a low oxidation state (see Scheme 5.2-2, route b)). Cavell and co-workers have observed oxidative addition on heating 1,3-dimethylimidazolium tetrafluoroborate with Pt(PPli3)4 in refluxing THF [32]. The Pt-carbene complex formed can decompose by reductive elimination. Winterton et al. have also described the formation of a Pt-car-bene complex by oxidative addition of the [EMIM] cation to PtCl2 in a basic [EMIM]C1/A1C13 system (free CP ions present) under ethylene pressure [33]. The formation of a Pt-carbene complex by oxidative addition of the imidazolium cation is displayed in Scheme 5.2-4. 

Kaeriyama and Shimura [34] have reported the photoinitiation of polymerization of MMA and styrene by 12 metal acetylacetonate complex. These are Mn(acac)3, Mo02(acac)2, Al(acac)3, Cu(bzac)2, Mg(acac)2, Co(a-cac)2, Co(acac)3, Cr(acac)3, Zn(acac)2, Fe(acac)3, Ni(a-cac)2, and (Ti(acac)2) - TiCU. It was found that Mn(a-cac)3 and Co(acac)3 are the most efficient initiators. The intraredox reaction with production of acac radicals is proposed as a general route for the photodecomposition of these chelates. 

A decade after Fischer s synthesis of [(CO)5W=C(CH3)(OCH3)] the first example of another class of transition metal carbene complexes was introduced by Schrock, which subsequently have been named after him. His synthesis of [((CH3)3CCH2)3Ta=CHC(CH3)3] [11] was described above and unlike the Fischer-type carbenes it did not have a stabilizing substituent at the carbene ligand, which leads to a completely different behaviour of these complexes compared to the Fischer-type complexes. While the reactions of Fischer-type carbenes can be described as electrophilic, Schrock-type carbene complexes (or transition metal alkylidenes) show nucleophilicity. Also the oxidation state of the metal is generally different, as Schrock-type carbene complexes usually consist of a transition metal in a high oxidation state. 

Abstract The photoinduced reactions of metal carbene complexes, particularly Group 6 Fischer carbenes, are comprehensively presented in this chapter with a complete listing of published examples. A majority of these processes involve CO insertion to produce species that have ketene-like reactivity. Cyclo addition reactions presented include reaction with imines to form /1-lactams, with alkenes to form cyclobutanones, with aldehydes to form /1-lactones, and with azoarenes to form diazetidinones. Photoinduced benzannulation processes are included. Reactions involving nucleophilic attack to form esters, amino acids, peptides, allenes, acylated arenes, and aza-Cope rearrangement products are detailed. A number of photoinduced reactions of carbenes do not involve CO insertion. These include reactions with sulfur ylides and sulfilimines, cyclopropanation, 1,3-dipolar cycloadditions, and acyl migrations. 

No CO-insertion products (metal-ketene complexes) were observed, even when specifically sought [9,10]. 

Several stable Group 6 metal-ketene complexes are known [14], and photo-driven insertion of CO into a tungsten-carbyne-carbon triple bond has been demonstrated [15]. In addition, thermal decomposition of the nonheteroatom-stabilized carbene complexes (CO)5M=CPh2 (M=Cr, W) produces diphenylke-tene [16]. Thus, the intermediacy of transient metal-ketene complexes in the photodriven reactions of Group 6 Fischer carbenes seems at least possible. 

Carbonyl Nitric Oxides. Another group of metal-carbonyl complexes, worthy of investigation as CVD precursors, consists of the carbonyl nitric oxides. In these complexes, one (or more) CO group is replaced by NO. An example is cobalt nitrosyl tricarbonyl, CoNO(CO)3, which is a preferred precursor for the CVD of cobalt. It is a liquid with a boiling point of 78.6°C which decomposes at 66°C. It is prepared by passing NO through an aqueous solution of cobalt nitrate and potassium cyanide and potassium hydroxide. ... 

The lobes of electron density outside the C-O vector thus offer cr-donor lone-pair character. Surprisingly, carbon monoxide does not form particularly stable complexes with BF3 or with main group metals such as potassium or magnesium. Yet transition-metal complexes with carbon monoxide are known by the thousand. In all cases, the CO ligands are bound to the metal through the carbon atom and the complexes are called carbonyls. Furthermore, the metals occur most usually in low formal oxidation states. Dewar, Chatt and Duncanson have described a bonding scheme for the metal - CO interaction that successfully accounts for the formation and properties of these transition-metal carbonyls. 

Several patents dealing with the use of volatile metal amidinate complexes in MOCVD or ALD processes have appeared in the literature.The use of volatile amidinato complexes of Al, Ga, and In in the chemical vapor deposition of the respective nitrides has been reported. For example, [PhC(NPh)2]2GaMe was prepared in 68% yield from GaMes and N,N -diphenylbenzamidine in toluene. Various samples of this and related complexes could be heated to 600 °C in N2 to give GaN. A series of homoleptic metal amidinates of the general type [MIRCfNROilnl (R = Me, Bu R = Pr, BuO has been prepared for the transition metals Ti, V, Mn, Fe, Co, Ni, Cu, Ag, and La. The types of products are summarized in Scheme 226. The new compounds were found to have properties well-suited for use as precursors for atomic layer deposition (ALD) of thin films. 

---