Mechanized molding processes

With the more mechanized molding processes, adequate space is obviously necessary, and special attention must be paid to safety precautions and guarding. The apparent simplicity of hand lay-up or spray-up should not lead one into thinking that generous space here is not equally essential. The ideal for all work is a large, airy, solid fectory building, free from draughts, and with a controlled temperature of 20-25C. 

SCRIMP process This Seeman Composites Resin Infusion Process (SCRIMP) is described as a gas-assist resin transfer molding process. As an example glass fiber fabrics/ thermoset vinyl ester polyester plastic and polyurethane foam panels (for insulation) are placed in a segmented tool. A vacuum is pulled with a bag so that a huge amount of plastic can be drawn into the mold (Marco process approach). Its curved roof is made separately and bonded to the box with mechanical and adhesive fastening. It is similar to various reinforced plastics molding processes. 

One typical example of carbon/carbon composite plates is that made by Oak Ridge National Laboratory (ORNL) in the United States [12]. The composite preform was fabricafed by a slurry-molding process from fhe mixed slurry befween short carbon fibers (graphite fibers were also added in some sample plates) and fhe phenolic resin. The mass rafio between fiber reinforcement and phenolic matrix is 4 3. The phenolic matrix improves the mechanical properties and dimensional stability of the plate. A subsequent vacuum molding process was utilized to fabricate composite plates and fluid fields with relatively high resolution (Figure 5.3, [11]). 

---