Apparent magnitude

The maximum differenee in erne observed for the eompounds with the same alkyl ehain length was well within 1.5 order of magnitude. Apparently, the alkyl ehain length is far more the determining factor for the cmc value than the type of carbohydrate and the nature of the group that links the head group and the alkyl chain. 

As a result of these difficulties the reported diffusivity data show many apparent anomaUes and inconsistencies, particularly for 2eohtes and other microporous adsorbents. Discrepancies of several orders of magnitude in the diffusivity values reported for a given system under apparendy similar conditions are not uncommon (18). Since most of the intmsive effects lead to erroneously low values, the higher values are probably the more rehable. 

Although the values caimot be considered absolute, approximate magnitude of taste sensitivity has been measured (Table 1). Certain taste interrelationships should be considered in the evaluation of taste magnitude. The apparent sourness of citric acid is depressed by both sucrose and sodium... 

The magnitude of the effect comes through even more clearly in Fig. 9-32, a plot of the time needed to reach a nominal (DCFRR) of 20 percent against the inflation rate for various values of (PBP). This plot also shows that the longer the payback period, the greater the increase in apparent profitability of the project. 

The resulting PL intensity depends on the absorption of the incident light and the mechanism of coupling between the initial excited states and the relaxed excited states that take part in emission. The spectrum is similar to an absorption spectrum and is useful because it includes higher excited levels that normally do not appear in the thermalized PL emission spectra. Some transitions are apparent in PLE spectra from thin layers that would only be seen in absorption data if the sample thickness were orders of magnitude greater. 

Comparison of the volume/volume composition data with the relative pressure data shows that although C2-C4 hydrocarbons are present to the greatest volume percent, their actual pressures are an order of magnitude lower than the C5 plus hydrocarbons. Hence, the C5 plus hydrocarbons would be adsorbed in preference to the C2-C4 hydrocarbons and would displace them over a number of cycles. It is apparent therefore that the C5 plus hydrocarbons must be considered the primary target gases for pre-adsorption in guard bed systems... 

True vs. apparent strength the visco-plastic energy dissipation dominated the magnitude of the peel strength. However, little dissipation occurs if the interface becomes very weak. In other words, some influxes are necessary to produce sufficient stress to activate the viscoelastic deformation in the body of the A. 

A slit die is designed on the assumption that the material is Newtonian, using apparent viscous properties derived from capillary rheometer measurements, at a particular wall shear stress, to calculate the volumetric flow rate through the slit for the same wall shear stress. Using the correction factors already derived, obtain an expression for the error involved in this procedure due to the melt being non-Newtonian. Also obtain an expression for the error in pressure drop calculated on the same basis. What is the magnitude of the error in each case for a typical power law index n = 0.377... 

---