Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Magnetic resonance spectroscopy signal source

The setup for ESR spectroscopy is a cross between NMR and micro-wave techniques (Section 5.8). The source is a frequency-stabilized klystron, whose frequency is measured as in microwave spectroscopy. The microwave radiation is transmitted down a waveguide to a resonant cavity (a hollow metal enclosure), which contains the sample. The cavity is between the poles of an electromagnet, whose field is varied until resonance is achieved. Absorption of microwave power at resonance is observed using the same kind of crystal detector as in microwave spectroscopy. Sensitivity is enhanced, as in microwave spectroscopy, by the use of modulation The magnetic field applied to the sample is modulated at, say, 100 kHz, thus producing a 100-kHz signal at the crystal when an absorption is reached. The spectrum is recorded on chart paper. [Pg.189]


See other pages where Magnetic resonance spectroscopy signal source is mentioned: [Pg.297]    [Pg.705]    [Pg.78]    [Pg.1179]    [Pg.1499]    [Pg.1569]    [Pg.1985]    [Pg.422]    [Pg.96]    [Pg.132]    [Pg.189]    [Pg.1179]    [Pg.1499]    [Pg.1569]    [Pg.1985]    [Pg.211]    [Pg.384]    [Pg.591]    [Pg.247]    [Pg.132]    [Pg.308]    [Pg.319]    [Pg.15]    [Pg.81]    [Pg.6501]    [Pg.866]    [Pg.851]   
See also in sourсe #XX -- [ Pg.743 ]

See also in sourсe #XX -- [ Pg.743 ]




SEARCH



Resonance signal

Signal source

© 2024 chempedia.info