Properties magnesium oxide

Prepare a saturated solution of sodium sulphide, preferably from the fused technical sodium polysulphide, and saturate it with sulphur the sulphur content should approximate to that of sodium tetrasulphide. To 50 ml. of the saturated sodium tetrasulphide solution contained in a 500 ml. round-bottomed flask provided with a reflux condenser, add 12 -5 ml. of ethylene dichloride, followed by 1 g. of magnesium oxide to act as catalyst. Heat the mixture until the ethylene dichloride commences to reflux and remove the flame. An exothermic reaction sets in and small particles of Thiokol are formed at the interface between the tetrasulphide solution and the ethylene chloride these float to the surface, agglomerate, and then sink to the bottom of the flask. Decant the hquid, and wash the sohd several times with water. Remove the Thiokol with forceps or tongs and test its rubber-like properties (stretching, etc.). 

Thermal Properties. Because all limestone is converted to an oxide before fusion or melting occurs, the only melting point appHcable is that of quicklime. These values are 2570°C for CaO and 2800°C for MgO. Boiling point values for CaO are 2850°C and for MgO 3600°C. The mean specific heats for limestones and limes gradually ascend as temperatures increase from 0 to 1000°C. The ranges are as follows high calcium limestone, 0.19—0.26 dolomitic quicklime, 0.19—0.294 dolomitic limestone, 0.206—0.264 magnesium oxide, 0.199—0.303 and calcium oxide, 0.175—0.286. 

M. Neuberger and D. B. Carter, Magnesium Oxide, Electronic Properties Information Center, Culver City, Calif, 1969, p. 3. 

Harper, F. C. (1967). Effect of calcination temperature on the properties of magnesium oxides for use in magnesium oxychloride cements. Journal of Applied Chemistry, 17, 5-10. 

NMR properties, 33 213, 274 in NMR studies of zeolites, 33 254-264 in sheet silicate studies, 33 342-345 -magnesium oxide catalyst, lattice parameter, 35 75... 

Comparing the two relative forces of electrostatic attraction that you calculated, you can conclude that ionic bonding is considerably stronger in magnesium oxide. This affects the physical properties and chemical behavior of the two compounds. For example, the melting point of MgO (2,852° C) is much higher than that of LiF (845° C). 

Bulk matter, rather than particles, is the subject of Part 2. In Chapter 9 we discuss classical theories of optical properties based on idealized models. Such models rarely conform strictly to reality, however, so Chapter 10 presents measurements for three representative materials over a wide range of frequencies, from radio to ultraviolet aluminum, a metal magnesium oxide, an insulator and water, a liquid. 

---