Regioselective lithiation

There are reports that other HMPA-organolithium complexes have a dramatic effect on lithiation regioselectivity away from coordination-favoured sites . ... 

The regioselectivity of the addition of terminal alkynes to epoxides is improved, when the reagents prepared from the lithiated alkynes and either trifluoroborane or chlorodiethyl-aluminum arc employed (M. Yamaguchi, 1983 S. Danishefsky, 1976). (Ethoxyethynyl)lithium-trifluoroborane (1 1) is a convenient reagent for converting epoxides to y-lactones (M. Naka-tsuka, 1990 see p. 327f. cf. S. Danishefsky, 1976). 

This procedure illustrates a general method for the preparation of alkenes from the pal 1 adium(Q)-cata1yzed reaction of vinyl halides with organo-lithium compounds, which can be prepared by various methods, including direct regioselective lithiation of hydrocarbons. The method is simple and has been used to prepare a variety of alkenes stereoselectively. Similar stoichiometric organocopper reactions sometimes proceed in a nonstereoselective... 

Regioselective lithiation of the formamidine 365 followed by tosylation afforded the corresponding 7-sulfone 367 which upon reaction with... 

Interestingly, treatment of bicyclic imidate 5 (R = OMe) with lithium diisopropylamide at — 78 C, followed by addition of iodomethane and quenching into ammonium chloride solution, gives 2-methoxy-3-methyl-37/-azepine. In the absence of iodomethane, 2-methoxy-3i/-azepine (6, R = OMe) is produced. Rearrangement of the lithiated bicycle to a lithiated 2-methoxy-3//-azepine, followed by regioselective trapping by the electrophile, is the most likely mechanistic rationale. 

In their synthesis of (+)-cerulenin, Mani and Townsend employed lithiated epoxysilane 157, which they trapped with (4E,7 )-nonadienal to give a 77% yield of 158, which was further manipulated to give the natural product (Scheme 5.37) [58], as-ot, 3-Epoxy-Y,S-vinylsilanes 159 are regioselectively lithiated at the a-silyl position, and can subsequently be stereo selectively trapped with a range of electrophiles to give a-substituted epoxyvinylsilanes 160, which can in turn be isomerized to a-silyl-P-vinylketones 161 (Scheme 5.38) [59]. 

The best conditions for the a-regioselective coupling of a chiral, highly substituted, lithiated allyl sulfide to a chiral aldehyde were carefully worked out for the key step in an erythronolide B total synthesis108. 

With titanated 2-alkenyl carbamates, the opposite regioselectivity can also be observed. Lithiated l-(4-methylphenylsulfonyl)-2-alkenyl diisopropylcarbamates, after metal exchange with chlorotriisopropoxytitanium, add to aldehydes y-selectivelylls. The less reactive titanat-ing reagent tetraisopropoxytitanium does not apparently react with these stabilized lithium carbanions, because in its presence a-selectivity is retained (Section 1.3.3.3.1.3.2.). 

The titaniated (25)-2,5-dihydro-2-isopropyl-3,6-dimethoxypyrazines derived from cyclo(L-Val, Gly) or cyclo(L-Val, Ala) (1, R1 = H, CH3) react with a,/I-unsaturatcd aldehydes exclusively by 1.2-addition (cf. nearly exclusive 1,4-addition of ,//-unsaturated ketones with cuprate complexes of 2,5-dialkoxy-3,6-dihydropyrazines, see Section D. 1.5.2.3.1.4.) in a highly diastereoselective mode to give virtually only the (l S,2R)-diastereoniers 2 ". In reactions with the corresponding lithiated pyrazines both regioselectivity and diastereofacial differentiation at C-2 are also remarkably high (dc 95 %), but the diastereomeric excess at C-l is substantially smaller (30 50%) ... 

The ort/to-directing effect of the carbonyl group in the regioselective lithiation of 2( 1/f) quinolinone has been studied by Avendano <9581362>. 

Electrophilic cyclization of the precursors 8, which are available from 3-(methylthio)pyridine by regioselective lithiation, followed by introduction of CBr4, and a subsequent Sonogashira coupling, has resulted in a series of thieno[3,2-b]pyridines 9... 

Indolylborates 142 (Z = Me, Boc, OMe), available via regioselective C-2 lithiation of indoles 141, are capable of undergoing palladium-catalyzed carbonylative cross-coupling... 

Addition of allylic zinc bromides to nitrones, generated in situ from allylbro-mides and zinc powder in THF (670), allyltributylstannane (671) and lithiated allyl ferf-butyldimethylsilyl ether (672), proceeds regioselectively in good yields and is used to synthesize homoallyl hydroxylamines (Scheme 2.189). The latter were subjected to an iodo cyclization reaction (see Scheme 2.186). 

Regioselective mono-acetylenation of 2,5-dibromopyridine with trimethylsilylacetylene afforded 2-trimethylsilylethynyl-5-bromopyridine (132) [108, 109]. The regioselectivity was in contrast to the lithiation of 2,5-dibromopyridine in which the 5-position was more reactive. 

Iodobenzofuran was readily prepared by lithiation of benzofuran followed by iodine quench [8]. Bromination of benzofuran with bromine gave 2,3-dibromobenzofuran, which, when subjected to a regioselective halogen/metal exchange at the C(2) position with n-BuLi followed by quenching with methanol furnished 3-bromobenzofuran [9]. 

---