Lining applications infrared spectra

Near-Infrared Spectroscopy. Near-infrared (NIR) spectroscopy is a technique that has been around for some time but, like NMR spectroscopy, has only recently been improved and developed for on-line applications. Near-infrared analysis (NIRA) is a nondestructive technique that is versatile in the sense that it allows many constituents to be analyzed simultaneously 112, 113). The NIR spectrum of a sample depends upon the anharmonic bond vibrations of the constituent molecules. This condition means that the temperature, moisture content, bonding changes, and concentrations of various components in the sample can be determined simultaneously. In addition, scattering by particles such as sand and clay in the sample also allows (in principle) the determination of particle size distributions by NIRA. Such analyses can be used to determine the size of droplets in oil-water emulsions. 

Fig. 2 shows one application of ATR depth profiling. In this case, ATR spectra were obtained as a function of angle of incidence from a polymethylmethacrylate (PMMA) film of thickness 0.5 p.m that was deposited onto a germanium hemi-cylinder [4]. The solid line represents the ATR spectrum of PMMA while the squares represent the film thickness that was recovered from the infrared spectra using four different bands. It can be observed that the recovered film thickness was very close to the measured thickness. 

By far the most common use of mid-infrared radiation for process analysis is in the non-dispersive infrared analysers that are discussed below. The widespread use of FTIR spectrometers in the mid-lR has yet to be fully realized in process analytical apphcations. The requirements for the optical components and the wavelength sta-bihty of the instraments available have, until recently, detracted from the use of this region of the spectrum in on-line process analysis. Optical fibers that provide such a benefit to the apphcations of NIR (see below) are not available for the mid-IR in robust forms or forms that are capable of transmitting over more than a few tens of metres. Improvements and developments to sample cells, particularly designs of attenuated total reflectance (ATR) cells, for use with mid-lR are being made and will influence the application of the technique. An impressive list of apphcations including both FTIR and the NDIR approaches has been compiled (2, 3]. 

The use of the DIAL method in the mid-infrared spectral region has arisen from the availability of the high-powered carbon dioxide laser and the wide range of species with absorption lines in the range 9-11 pm. However, the carbon dioxide laser cannot be tuned continuously across the spectrum so it is not possible to use a single carbon dioxide laser to measure all the species that have absorption lines in this region of the spectrum. Possible applications include ... 

---