Layer, 119 Anatase

Figure 13 Time-Resolved Raman spectra of a single-layer anatase (Ti02) film as a function of temperature showing irreversible transformation to a rutile phase.

After gas-phase oxidation reaction finished, the reactor wall surfece was coated with a thick rough scale layer. The thickness of scale layer along axial direction was varied. The scale layer at front reactor was much thicker than that at rear. The SEM pictures were shown in Fig. 1 were scale layers stripped from the reactor wall surface. Fig. 1(a) was a cross sectional profile of scale layer collected from major scaling zone. Seen from right side of scale layer, particles-packed was loose and this side was attached to the wall surface. Its positive face was shown in Fig. 1(b). Seen from left side of scale layer, compact particles-sintered was tight and this side was faced to the reacting gases. Its local amplified top face was shown in Fig. 1(c). The XRD patterns were shown in Fig. 2(a) were the two sides of scale layer. Almost entire particles on sintered layer were characterized to be rutile phase. While, the particle packed layer was anatase phase. 

Besides, without addictive AICI3 as a crystal conversion agent, phase composition of most neogenic Ti02 particles was anatase in our experiment. Conversions active energy finm anatase to rutile was 460 kJ/mol [5], with temperature arose, crystal conversion rate as well as mass fraction of rutile would increase [6,7]. Hence, after a lot of heat accumulated, phase composition of particle-sintered layer was rutile. 

In eomparison, the Te-type deposits contain fine-grained quartz, chalcedonic quartz, sericite, barite, adularia, ehlorite/smectite interstratified mixed layer clay mineral and rarely anatase. Carbonates and Mn-minerals are very poor in the Te-type deposits and they do not coexist with Te-minerals. Carbonates are abundant and barite is absent in the Se-type deposits. The grain size of quartz in the Te-type deposits is very fine, while large quartz crystals are common in the Se-type deposits although they formed in a late stage and do not coexist with Au-Ag minerals. 

Fig. 3 Suggested scheme for the transformation of layered titanate to anatase Ti02 nanoroad. The structure models presented are the projection along the nanotube axis, i.e., the [010] of the titanate. The final TiOz nanorod product shown is the (010) face of the anatase phase. Elaborated from the picture reported by Nian and Teng.165...

Characteristic microstructural properties of TiOj membranes produced in this way are given in Table 2.5. Mean pore diameters of 4-5 nm were obtained after heat treatment at T < 500°C. The pore size distribution was narrow in this case and the particle size in the membrane layer was about 5 nm. Anderson et al. (1988) discuss sol/gel chemistry and the formation of nonsupported titania membranes using the colloidal suspension synthesis of the type mentioned above. The particle size in the colloidal dispersion increased with the H/Ti ratio from 80 nm (H /Ti = 0.4, minimum gelling volume) to 140 nm (H /Ti " — 1.0). The membranes, thus prepared, had microstructural characteristics similar to those reported in Table 2.5 and are composed mainly of 20 nm anatase particles. Considerable problems were encountered in membrane synthesis with the polymeric gel route. Anderson et al. (1988) report that clear polymeric sols without precipitates could be produced using initial water concentrations up to 16 mole per mole Ti. Transparent gels could be obtained only when the molar ratio of H2O to Ti is < 4. Gels with up to 12 wt.% T1O2 could be produced provided a low pH is used (H /Ti + < 0.025). 

Imai H, Takei Y, Shimizu K, Matsuda M, Hirashima H (1999) Direct preparation of anatase Ti02 nanotubes in porous alumina membranes. J Mater Chem 9 2971-2972 Michailowski A, A1 Mawlawi D, Cheng GS, Moskovits M (2001) Highly regular anatase nanotubule arrays fabricated in porous anodic templates. Chem Phys Lett 349 1-5 Jung JH, Kobayashi H, van Bommel KJC, Shinkai S, Shimizu T (2002) Creation of novel helical ribbon and double-layered nanotube Ti02 structures using an... 

---