Knoop indentor

Vickers and Knoop indentors, Barcol hardness, and Shore durometers (2) (b) to measure the resistance of a material to scratching by another material or by a sharp point, such as the Bierbaum hardness or scratch-resistance test and the Moh one for hardness and (c) to measure rebound efficiency or resilience, such as the various Rockwell hardness tests. The various tests provide different behavior characteristics for plastics, as described by different ASTM standards such as D 785. The ASTM and other sources provide different degrees of comparison for some of these tests. 

The Knoop test is a microhardness test. In microhardness testing the indentation dimensions are comparable to microstructural ones. Thus, this testing method becomes useful for assessing the relative hardnesses of various phases or microconstituents in two phase or multiphase alloys. It can also be used to monitor hardness gradients that may exist in a solid, e.g., in a surface hardened part. The Knoop test employs a skewed diamond indentor shaped so that the long and short diagonals of the indentation are approximately in the ratio 7 1. The Knoop hardness number (KHN) is calculated as the force divided by the projected indentation area. The test uses low loads to provide small indentations required for microhardness studies. Since the indentations are very small their dimensions have to be measured under an optical microscope. This implies that the surface of the material is prepared approximately. For those reasons, microhardness assessments are not as often used industrially as are other hardness tests. However, the use of microhardness testing is undisputed in research and development situations. 

Quantitative hardness tests slowly apply a fixed load to an indentor that is forced into the smooth surface of the specimen. After the load is removed, either the diameter across the impression or the depth of the impression is measured. The size of the penetration is proportional to the material s hardness. Rockwell, Brinnell, Vickers, and Knoop are well-known indentation hardness testing instruments. 

The indentor used in the Knoop hardness is a diamond pyramid, but the lengths of the two diagonals, as shown in Figure 3.42, are different. If the long diagonal of the indent is measured as D, the hardness number is obtained from... 

---