Amines ketones, cyclic

The secondary amines used in the preparation of enamines have been primarily simple dialkylamines or cyclic amines of five- or higher-membered rings. Azetidine (4) yields a stable enamine with cyclopentanone (28). No simple enamines formed by condensation of ethylenimine (5) or a substituted ethylenimine with an aldehyde or ketone have been reported. 

The net effect of the Stork reaction is the Michael addition of a ketone to an cn/3-unsaturated carbonyl compound. For example, cyclohexanone reacts with the. cyclic amine pyrrolidine to yield an enamine further reaction with an enone such as 3-buten-2-one yields a Michael adduct and aqueous hydrolysis completes the sequence to provide a 1,5-diketone (Figure 23.8). 

When enamines are treated with alkyl halides, an alkylation occurs that is analogous to the first step of 12-14. Hydrolysis of the imine salt gives a ketone. Since the enamine is normally formed from a ketone (16-12), the net result is alkylation of the ketone at the a position. The method, known as the Stork enamine reaction is an alternative to the ketone alkylation considered at 10-105. The Stork method has the advantage that it generally leads almost exclusively to monoalkylation of the ketone, while 10-105, when applied to ketones, is difficult to stop with the introduction of just one alkyl group. Alkylation usually takes place on the less substituted side of the original ketone. The most commonly used amines are the cyclic amines piperidine, morpholine, and pyrrolidine. 

Aldol-type reactions of nitrones (303) occur with electron-deficient ketones, such as a-keto esters, a, 3-diketones, and trifluoromethyl ketones. These reactions are catalyzed by secondary amines. The use of chiral cyclic amines A1-A7 leads to a-(2-hydroxyalkyl)nitrones (304) in moderate yields and rather high optical purity (Scheme 2.120) (381). The mechanism of the nitrone-aldol reaction of iV-methyl-C-ethyl nitrone with dimethyl ketomalonate in the absence and presence of L- proline has been studied by using density functional theory (DFT) (544). 

Oxidative attack on a carbon-hydrogen bond of an alkyl group a to a nitrogen atom is not restricted to saturated aliphatic amines. In fact X in an X-N-CH- structural subunit can be virtually any common atomic grouping that can be found in stable organic molecules. For example, w-carbon hydrogens of Aralkyl-substituted aromatic cyclic amines (119), aryl amines (120), amides (121), amidines (122), A-nitrosodialkylamines (123), etc. are all subject to oxidative attack, carbinolamine formation, and in most cases release of an aldehyde or ketone depending on the substitution pattern (1° or 2°)... 

Qualitative spot tests for aldehydes, in the presence of ketones, are generally only reliable for water-soluble compounds. This problem can be overcome by the use of 4-amino-3-hydrazino-5-mercapto-1,2,4-triazole (Purpald , Aldrich Chemical Company) in the presence of Aliquat (Scheme 5.27). Under aerial oxidation, the initially formed colourless cyclic adduct changes colour through red to purple. The colourless cyclic aminal can also be formed by ketones, but only the adducts derived from the aldehydes are oxidized to the purple bicyclic aromatic system [28]. Weakly electrophilic aldehydes, e.g., 4-methoxybenzaldehyde, reacts slowly, but will give the positive coloration upon gentle heating to ca. 70°C for one or two minutes. 

Most enamines, unfortunately, are sensitive to hydrolysis. The parent enamine, iV,iV-dimethylvinylamine, has in fact been prepared [3], but appears to be unstable. Enamines of cyclic ketones and many aldehydes can readily be isolated, however [4-7]. The instability of enamines might at first appear to diminish the utility of enamines as nucleophiles, but actually this property can be viewed as an added benefit enamines can be readily and rapidly generated catalytically by using a suitable amine and a carbonyl compound. The condensation of aldehydes or ketones with amines initially affords an imine or iminium ion, which then rapidly loses a proton to afford the corresponding enamine (Scheme 1). 

The Ugi-4CR between cyclic ketones, primary amine hydrochlorides, potassium thiocyanate (or selenocyanate), and 2,2-diethoxyethyl isocyanide [91] afforded the spiro 2-thio-(or seleno)hydantoin-4-imines 166. On heating in acetic acid, compounds 166 underwent carbonyl deprotection and cyclization to spiro imidazo[l,5-ajimidazoles 167 (Scheme 2.60). 

These are the most favourable of all and the precursors, such as the hydroxy acids, e.g. 15, cannot usually be isolated, though the carboxylate salts are stable. The only important thing is to get the oxidation level of the precursor right. Using cyclic amines as examples, a fully saturated ring 45 would come from an alkylation reaction on 46 X = a leaving group. Imines 47 or enamines 49 would come from aldehydes or ketones 48. 

The electrooxidative properties of some enamines derived from cyclic ketones and cyclic amines have been studied in detail1. It has been found that the electrooxidation is irreversible and the peak potentials (Table 1) are rather low, as expected on the basis of the chemical reactivity of the enamines. 

Dehydrogenations, which involve the elimination of hydrogen Ifom organic molecules, lead to compounds containing double bonds, multiple bonds, or aromatic rings. For practical reasons, only the formation of carbon-carbon double bonds, of carbon-nitrogen double bonds in cyclic amines, and of aromatic rings (both carbocyclic and heterocyclic) will be discussed in this chapter. The conversion of alcohols into aldehydes and ketones and of amines into imines and nitriles will be discussed in the chapter Oxidations (Chapter 3). 

Morpholine is a secondary, cyclic amine which reacts with aldehydes and ketones to give enamines with the formation of water. 

Synthetic and biological interest in highly functionalized acyclic and cyclic amines has contributed to the wealth of experimental methodology developed for the addition of carbanions to the caibon-mtrogen double bond of imines/imine derivatives (azomethines). While a variety of practical methods exist for the enantio- and stereo-selective syntheses of substituted alcohols from aldehyde and ketone precursors, related imine additions have inherent structural limitations. Nonetheless imines, by virtue of nitrogen substitution, add a synthetic dimension not available to ketones. In addition, improved procedures for the preparation and activation of imines/imine derivatives have increased the scope of the imine addition reaction. 

A very comprehensive analysis of hydrocarbons (linear, acyclic and cyclic - steranes, hopanes etc.- isoprenoids) carboxylic acids, aldehydes, ketones and amines of the Vale do Paraiba and Marau oil shales was made by Chicarelli (27). An extremely careful quantitative and qualitative analysis of hydrocarbons (n-, iso-and anteiso-paraffins, isoprenoids, steranes and triterpanes) and carboxylic acids of Irati oil shale was presented by Carvalhaes (28). Nooner Oro (29) also reported data on the hydrocarbons pres ent in the Irati Formation. Polycyclic aromatic hydrocarbons in I-rati were determined by Youngblood Blumer (40). 

Recently, two other groups have shown that exocyclic iminium salts can be useful mediators in asymmetric epoxidation. Komatsu has developed a system based on ketiminium salts [14], prepared through the condensation of aliphatic cyclic amines with ketones. A chiral variant was also produced, derived from prolinol and cyclohexanone, which gave 70% yield and 39% ee for cinnamyl alcohol (Scheme 5.7). 

Enamines show an amplified preference for the less substituted double bond at first this seems to contradict what we have just said, but the effect is greatest in cyclic ketones, e.g. 17, with cyclic amines.41 It is steric in origin and arises from the eclipsing of hydrogen atoms (A13 strain) shown in the more substituted enamine 19. Enamines of acyclic ketones can be persuaded to give only the less substituted regio-isomer by equilibration of the immonium salt in weak base.5... 

Other synthetic applications derive from various cyclizations that occur during reduction of the substrates that contain a reactive function at a specific position. These cyclizations proceed through the intermediate imine or amine to the cyclic amine. Various functional units such as olefins, heterocyclic rings, ketones, acids, amides, amines, nitrile, and nitro have been involved. Palladium, Rh, and finely divided Ni (Raney Ni) under more vigorous conditions are commonly used. Reductive cyclization of ketonitrile 1 over Raney Ni gives myosmine 2 along with some nomicotine 3 as overreduced product ... 

---