Ketals hemiketals

Theoretical studies have been done in order to understand this behavior difference. Semiempirical calculations (AMI, MNDO) of formation energy (of the hemithio-ketal-hemiketal interconversion) have shown that hemithioketals are less stable than the corresponding hemiketal (from 10 to 15 kcal/mol). This difference can be due to steric factors, connected to the respective sizes of sulfur and oxygen. Stereoelectronic factors can also be evoked stabilization that is brought about by the anomeric effect is a priori more important for a gem-dihydroxylated compound than for the hemi-thioketal. Moreover, at the kinetic level, displacement of the water molecule of the inhibitor (under aqueous conditions, the inhibitor is hydrated) by the thiol of the enzyme is a slow and disfavored reaction. In contrast, the same reaction is favored with the hydroxyl of a serine. Experimentally, equilibrium occurs very slowly with the enzyme as well as with model molecules. ... 

Problem 14.23. For each of the following, indicate whether the compound is an acetal, hemiacetal, ketal, hemiketal, or something else ... 

Palytoxin carboxylic acid, C,23H2i3N053 (Figure 1, R -R = H), derived from palytoxin, C,29H223N3054, contains 41 hydroxyl groups, one amino group, one ketal, one hemiketal, and one carboxylic acid, in addition to some double bonds and ether linkages. 

This order was chosen so that DDQ (dichlorodicyanobenzoquinone) treatment would not oxidize a dep otected allylic alcohol at C.73, and so that the C.47 hemiketal would still be protected (as the ketal) during basic hydrolysis (step 3). 

Aldehydes and ketones undergo reversible addition reactions with alcohols. The product of addition of one mole of alcohol to an aldehyde or ketone is referred to as a hemiacetal or hemiketal, respectively. Dehydration followed by addition of a second molecule of alcohol gives an acetal or ketal. This second phase of the process can be catalyzed only by acids, since a necessary step is elimination of hydroxide (as water) from the tetrahedral intermediate. There is no low-energy mechanism for base assistance of this... 

The second step in acetal and ketal hydrolysis is conversion of the hemiacetal or hemiketal to the carbonyl compound. The mechanism of this step is similar to that of the first step. Usually, the second step is faster than the initial one. Hammett a p plots and solvent isotope effects both indicate that the transition state has less cationic character than... 

As with isolated rings, individual heterorings in fused systems which are synthetic equivalents of acyclic subunits, e.g. lactone, ketal, lactam, and hemiketal, can be disconnected. 

FIGURE 7.16 Acetals and ketals can be formed from hemiacetals and hemiketals, respectively. 

A value of kjkp = 17 000 has been determined for partitioning of the acetophenone oxocarbenium ion [12+] in water.15,16 It is not possible to estimate an equilibrium constant for the addition of water to [12+], because of the instability of the hemiketal product of this reaction. However, kinetic and thermodynamic parameters have been determined for the reaction of [12+] with methanol to form protonated acetophenone dimethyl ketal [12]-OMeH+ and for loss of a proton to form a-methoxystyrene [13] in water (Scheme 10).15,16 Substitution of these rate and equilibrium constants into equation (3) gives values of AMeoH = 6.5 kcal mol-1 and Ap = 13.8 kcal mol-1 for the intrinsic... 

Reduction of Acetals, Ketals, Hemiacetals, Hemiketals, and Orthoesters... 

Table 20. organosilane reduction of acetals, ketals, and hemiketals... 

TABLE 20. ORGANOSILANE REDUCTION OF ACETALS, KETALS, AND HEMIKETALS (Continued)... 

OXYGEN AS A NUCLEOPHILE HEMIACETALS, HEMIKETALS, ACETALS AND KETALS... 

---