Integrated Relief Evaluation

Grolmes, M. A. and J. C. Leung, "Code Method for Evaluating Integrated relief Phenomena," Chem. Eng. Prog., 81,47 (1985). 

In some ceises the influence functional F may be teiken out of the integrals over the imit cell in (2.2.2). It is possible either when Pi(Rc) and Gqq(Ro) depend on Rq weakly compared to GUq is, when the crystal corrugation is much smaller than the phonon relief), or when S Ro) oscillates strongly enough for the evaluation of the integrals by the stationary phase method (the classical limit). In the latter case F is treated as a pre-exponential factor and may be replaced with its value at the stationary phase point. Then the general structural factor Hq can be factorized into the product of the form factor (diffi action intensities) and the dynamic structural factor ... 

The loop contains pressure relief valves or burst disks, to prevent over temperature and overpressure of the loop. Additional transient analyses with system control actions and testing would need to be performed to evaluate off nominal scenario s which may lead to needing or not needing pressure/temperature protection. Future testing and analysis would determine the acceptability of boiling within the gas cooler, and the method of integrating a temperature protection system for the heat pipe evaporators. 

---