Hydrogen production high-rate reactors

High-rate reactor for fermentative hydrogen production 272... 

High-Rate Reactor for Fermentative Hydrogen Production... 

Reactions were carried out in liquid phase in a well-stirred (1000 rpm) high-pressure reactor (Parr Instruments, 300 mL) at 30 bar and 150°C. The reaction mixture consisted of 61 g of ADPA (Acros Chemicals), 53 g MIBK (Acros Chemicals) and 370 mg of catalyst. The test procedures used here is similar to that described earlier by Bartels et al. (7). The reactor was operated at a constant pressure with the liquid phase in batch mode and the hydrogen fed in at a rate proportional to its consumption. The reaction was monitored by hydrogen uptake and the product yield was determined from gas chromatographic (Agilent Technologies, 6890N) analysis. 

CO reactants and the H2O product of the synthesis step inhibit many of these secondary reactions. As a result, their rates are often higher near the reactor inlet, near the exit of high conversion reactors, and within transport-limited pellets. On the other hand, larger olefins that are selectively retained within transport-limited pellets preferentially react in secondary steps, whether these merely reverse chain termination or lead to products not usually formed in the FT synthesis. In later sections, we discuss the effects of olefin hydrogenation, oligomerization, and acid-type cracking on the carbon number distribution and on the functionality of Fischer-Tropsch synthesis products. We also show the dramatic effects of CO depletion and of low water concentrations on the rate and selectivity of secondary reactions during FT synthesis. 

---