Hydrogen activation temperature dependence

The mechanism and rate of hydrogen peroxide decomposition depend on many factors, including temperature, pH, presence or absence of a catalyst (7—10), such as metal ions, oxides, and hydroxides etc. Some common metal ions that actively support homogeneous catalysis of the decomposition include ferrous, ferric, cuprous, cupric, chromate, dichromate, molybdate, tungstate, and vanadate. For combinations, such as iron and... 

Effect of Temperature and pH. The temperature dependence of enzymes often follows the rule that a 10°C increase in temperature doubles the activity. However, this is only tme as long as the enzyme is not deactivated by the thermal denaturation characteristic for enzymes and other proteins. The three-dimensional stmcture of an enzyme molecule, which is vital for the activity of the molecule, is governed by many forces and interactions such as hydrogen bonding, hydrophobic interactions, and van der Waals forces. At low temperatures the molecule is constrained by these forces as the temperature increases, the thermal motion of the various regions of the enzyme increases until finally the molecule is no longer able to maintain its stmcture or its activity. Most enzymes have temperature optima between 40 and 60°C. However, thermostable enzymes exist with optima near 100°C. 

What happens to the methoxy formed by this process is strongly temperature dependent. At low temperature (up to - 340K) it is stable on the surface and forms the beautiful structures shown in fig.2. Since the active oxygen is used in such reactions then the methoxy must (i) not block the active site at its formation or (ii) diffuses away from the active site. Our evidence indicates the latter to be the case since methoxy is present at sites away from the oxygen islands. Above approximately 340 K the methoxy is unstable and decomposes to yield formaldehyde and hydrogen in the gas phase. Above approximately 400 K, the stoichiometry of the reaction changes to... 

Uchida H, Izumi K, Watanabe M. 2006. Temperature dependence of CO-tolerant hydrogen oxidation reaction activity at Pt, Pt-Co, and Pt-Ru electrodes. J Phys Chem B 110 21924-21930. 

Fig. 5.25. Temperature dependence of the starting velocity of change in Au/ZnO film being acted upon by helium metastable atoms after different preliminary treatment [174] (/ - film treated by active hydrogen 2- starting film 3 - film treated by active oxygen)...

Apparent activation energy, kcal/mole, determined from the temperature dependence of the rate n at ethane and hydrogen partial pressures of 0.030 and 0.20 atm, respectively. 

Raising the incubation temperature from 45 to 57°C did not bring about a pronounced increase of the hydrogen-driven pMMO activity. This preliminary observation indicated in vivo heat stability of the hydrogenase and pMMO activities. The temperature dependent difference in the solubility of hydrogen may also explain the small activity difference, particularly as similar results were obtained for the hydrogen-driven sMMO activity. 

The SHE. The H" " H2 couple is the basis of the primary standard around which the whole edifice of electrode potentials rests. We call the H H2 couple, under standard conditions, the standard hydrogen electrode (SHE). More precisely, we say that hydrogen gas at standard pressure, in equilibrium with an aqueous solution of the proton at unity activity at 298 K has a defined value of of 0 at all temperatures. Note that all other standard electrode potentials are temperature-dependent. The SHE is shown schematically in Figure 3.3, while values of Eq r are tabulated in Appendix 3. 

Finally we compare the temperature dependencies reported for the structural relaxation and the self-motion of hydrogens studied by NSE. For PI, the shift factors used for the construction of the master curve on Q,T) (Fig. 4.17) are identical to those observed for the structural relaxation time [8]. This temperature dependence also agrees with DS and rheological studies. The case of PIB is more complex [ 147]. The shift factors obtained from the study of Teif(Q>T) (Fig. 4.14b) reveal an apparent activation energy close to that reported from NMR results (-0.4 eV) [136]. This temperature dependence is substantially weaker than that observed for the structural relaxation time (=0.7 eV, coinciding with rheological measurements) in the same temperature range (see Fig. 4.20). 

In most cases the catalytically active metal complex moiety is attached to a polymer carrying tertiary phosphine units. Such phosphinated polymers can be prepared from well-known water soluble polymers such as poly(ethyleneimine), poly(acryhc acid) [90,91] or polyethers [92] (see also Chapter 2). The solubility of these catalysts is often pH-dependent [90,91,93] so they can be separated from the reaction mixture by proper manipulation of the pH. Some polymers, such as the poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) block copolymers, have inverse temperature dependent solubihty in water and retain this property after functionahzation with PPh2 and subsequent complexation with rhodium(I). The effect of temperature was demonstrated in the hydrogenation of aqueous allyl alcohol, which proceeded rapidly at 0 °C but stopped completely at 40 °C at which temperature the catalyst precipitated hydrogenation resumed by coohng the solution to 0 °C [92]. Such smart catalysts may have special value in regulating the rate of strongly exothermic catalytic reactions. 

Fig. 2. Dependence of basicity and catalytic activity on calcination temperature of CaO (O) Basic sites with > 15 ( ) relative activity for Tishchenko reaction of benzaldehyde ( ) number of reducing sites ( ) activity for styrene polymerization and (A) relative propene hydrogenation activity ( ).

---