High-density polyethylene molecular weight

HDPE melts at about 135°C, is over 90% crystalline, and is quite linear, with more than 100 ethylene units per side chain. It is harder and more rigid than low density polyethylene and has a higher melting point, tensile strength, and heat-defiection temperature. The molecular weight distribution can be varied considerably with consequent changes in properties. Typically, polymers of high density polyethylene are more difficult to process than those of low density polyethylene. 

High density polyethylene, shown in Fig. 18.2 a), consists primarily of linear hydrocarbon chains of the type shown in Fig. 18.1. We commonly abbreviate its name to HDPE. As with all other polymers, high density polyethylenes contain a distribution of molecular weights. The molecules have few, if any, branches. 

A small number of companies use metal oxide catalysts, such as the example shown in Fig. 18.6, to make high density polyethylene. The polyethylene made with this catalyst generally has a narrower molecular weight distribution than high density polyethylene made with Ziegler-Natta catalysts. 

EFFECT OF MOLECULAR WEIGHT ON MECHANICAL AND MORPHOLOGICAL PROPERTIES OF HIGH DENSITY POLYETHYLENE FOAMS... 

HA HAP HC HCFC HDPE HDR Humic acid Hazardous air pollutant Hydrocarbon (molecular weight 13 g/mol) Hydrochlorofluorocarbon High-density polyethylene Hot-dry-rock... 

Although some polymers may be satisfactory when used under the stress of static loads, they may fail when subjected to impact. The impact resistance, or resistance to brittle fracture, is a function of the molecular weight of a polymer. Thus uhmwpe is much more resistant to impact failure than general purpose high-density polyethylene (hdpe). The impact resistance of brittle polymers is also increased by the addition of plasticizers. Thus polyvinyl chloride (PVC), plasticized by relatively large amounts of dioctyl phthalate, is much less brittle than unplasticized rigid PVC. 

Ethylene Polymers. Depending on the polymerization conditions, three major types of polyethylene are manufactured low-density polyethylene (LDPE) by free-radical polymerization, linear low-density polyethylene (LLDPE) by copolymerization of ethylene with terminal olefins, and high-density polyethylene (HDPE) by coordination polymerization. The processes yield polymers with different characteristics (molecular weight, molecular weight distribution, melt index, strength, crystallinity, density, processability). 

---