Gravity tensile

Hardness Specific gravity Tensile strength. Modulus of elasticity, GN/m Thermal conductivity, W/(m-K) Coefficient of expansion, 10-6"C... [Pg.1]

Tliermosets Specific gravity Tensile strength ModiUns of elasticity, tension Impact strength, lzod Maximum use temperature (no load) HDT at 2.54 Ib in -" Chemical resistance s ... [Pg.2465]

Specific gravity Tensile strength Tensile modulus Elongation Dielectric Constant... [Pg.513]

Reinforcing material Specific gravity Tensile Strength modulus Compressive strength, 10 psi Flexural strength, 10 psi Izod impact strength, ft-lb/in. Heat resistance continuous, Arc resistance,... [Pg.466]

These five factors are difficult to measure and control routinely due to a need for special equipment and procedures. A number of indirect properties have been defined to measure the impact of the five parameters. They include specific gravity, tensile strength, break elongation, dielectric breakdown strength, and heat of fusion. These properties are measured by relatively simple and quick methods. [Pg.350]

Specific gravity Tensile strength/MPa Flexural strength/MPa Water absorption/%... [Pg.71]

Resin Specific gravity Tensile strength, MPo Tensile modulus, GPa Elongation, % Flexural strength, MPa Flexural modulus, GPa Izod impact notched, Jim Deflection temperature under load, C... [Pg.3]

Base polymer Reinforcement, wt. % Specific gravity Tensile modulus, GPa (Mpsi) Notched Izod impact strength, Jim (6.4mm bar) (ft-lb/in. %"bar) Surface resistivity, ohms/sq. Shielding effectiveness db attenuation ICPMHz, 6.4mm (Ts") thick. [Pg.67]

Ratio of carbon/ aramid fibers Specific gravity Tensile modulus, Vf psi Stre at0.02%ofket, Kfi psi Compression Flexure ... [Pg.74]

Type Specific gravity Tensile strength MPa (Kpsij Tensile modulus GPo (Kpsi) Deflection Notched Izod temperature impact strength °C 182 MPa J/m (5.4 mm thick) (°F 264psi) (ft-lb/in., 1/4 in.) Approximate relative volumetric cost... [Pg.889]

Material Specific gravity Tensile strength, psi Elastic modulus, ksi r c T C... [Pg.279]

Specific gravity Tensile strength N/mm Tensile modulus kN/mm Elongation at break % Flexural strength N/mm ... [Pg.49]

Specific gravity Tensile modulus Flexural modulus Tensile strength Flexural strength Impact strength Thermal expansion Heat deflection temperature Dielectric constant Volume resistivity Water absorption... [Pg.141]

Specific gravity Tensile strength Tensile modulus Ductility, elongation Resistance to creep Max. usage temperature Shrinkage and warpage Flow... [Pg.70]

Matrix Reinforcement Fiber Percent by Vol. Specific Gravity Tensile Strength, psi Tensile Modnliis,psi Ultimata Elongation, % Cnive Ana in. Bi/in ... [Pg.38]

Teflon Melt Flow Rate, g/10 min Melting Point, °C Specific Gravity Tensile Strength at 23°C, MPa Elongation at Break at 23°C, % Dielectric Constant at 23°C, 10 -10 Hz Dissipation Factor at 23 C, 10 -10 Hz... [Pg.125]