Glass transition temperature requirements

Some polymers are not elastomeric under normal conditions but can be made so by raising the temperature or adding a diluent (plasticizer). Polyethylene is in this category because of its high degree of crystallinity. Polystyrene, poly(vinyl chloride), and the biopolymer elastin are also of this type, but because of their relatively high glass transition temperatures require elevated temperatures or addition of diluent to make them elastomeric [9],... 

Relatively few processible polyimides, particularly at a reasonable cost and iu rehable supply, are available commercially. Users of polyimides may have to produce iutractable polyimides by themselves in situ according to methods discussed earlier, or synthesize polyimides of unique compositions iu order to meet property requirements such as thermal and thermoxidative stabilities, mechanical and electrical properties, physical properties such as glass-transition temperature, crystalline melting temperature, density, solubility, optical properties, etc. It is, therefore, essential to thoroughly understand the stmcture—property relationships of polyimide systems, and excellent review articles are available (1—5,92). 

The most desirable annealing temperatures for amorphous plastics, certain blends, and block copolymers is just above their glass transition temperature (Tg) where the relaxation of stress and orientation is the most rapid. However, the required temperatures may cause excessive distortion and warping. 

Orientation and mobility Orientation requires considerable mobility of large segments of the plastic molecules. It cannot occur below the glass transition temperature (Tg). The plastic temperature is taken just above Tg. 

Calculated Degree of Maleic Anhydride Grafting Required to Obtain a Solubility Parameter of 18.0 (J/cm ) , Assuming Full Conversion of the Grafted Anhydride with the Amines Listed, and Corresponding Glass Transition Temperatures (Tg)... 

---