Glass surface energy

Because water of depths below about 2 m does not absorb much solar radiation direcdy, the radiation is absorbed and converted to heat primarily in the basin floor, which thus should have high radiative absorptance in the solar radiation spectmm. It is also noteworthy that if the stUl is designed to have low heat losses to the ambient, and if the ambient temperature drops, distillation will continue for some time even in the absence of solar energy input, because the saline water may remain warmer than the condensing glass surface and thus continue evaporating. 

Fluorinated poly(arylene edier)s are of special interest because of their low surface energy, remarkably low water absorption, and low dielectric constants. The bulk—CF3 group also serves to increase the free volume of the polymer, thereby improving various properties of polymers, including gas permeabilities and electrical insulating properties. The 6F group in the polymer backbone enhances polymer solubility (commonly referred to as the fluorine effect ) without forfeiture of die thermal stability. It also increases die glass transition temperature with concomitant decrease of crystallinity. 

Extremely low Glass Transition Temperatures —123 °C) Very low Surface Energies (20-21 dynes/cm) Hydrophobicity... 

Solutions to the above problea are required if efficient open tubular colunns are to be prepared. The energy of the saooth glass surface can Sse Increased by roughening or chemical Modification, or the surface tension of the stationary phase can be lowered by the addition of a surfactant. Roughening and/or cheMical modification etre the most widely used techniques for column preparation the addition of a surfactant, although effective, modifies the separation properties of the stationary phase and may also limit the thermal sted>ility of columns prepared with high temperature stable phases. 

Figure 11. Effect of the solution pH on the potential energy of 10 pm glass particles interacting with glass surfaces.

Plates of glass, PTFE, dolomite and marble were used. Dolomite and marble were chosen because they represent minerals found in oil reservoirs. Glass and PTFE were investigated because they represent high and low surface energy solids respectively and are good model systems for data comparisons. Liquid/solid wetting cycles were obtained for each of the solids in the liquids listed in Table III. 

---