Gears bevel gear

Bevel, zerol Same ratings as straight bevel gears and use same mountings, permits slight errors in assembly, permits some displacement due to deflection under load, highly accurate, hardened due to grinding Limited to speeds less than 1000 fpm due to noise... 

Bevel gears are used most frequently for 90° drives, but other angles can be accommodated. The most typical application is driving a vertical pump with a horizontal driver. 

As with spur gears, the tooth size of bevel gears is established by the diametrical pitch. Because the tooth size varies along its length, measurements must be taken... 

Figure 39.9 Basic cone shape of bevel gears...

Because there generally is no room to support bevel gears at both ends due to the intersecting shafts, one or both gears overhang their supporting shafts. This is... 

Figure 57.13 shows a typical pair of bevel gears. As with other gears, the term pinion and gear refers to the... 

Straight bevel gears, also known as plain bevels, are the most commonly used and simplest type of bevel gear (Figure 57.15). They have teeth cut straight across the face of the gear. They are recommended for peripheral speeds up to 1,000 feet per minute in cases where quietness and maximum smoothness are not cmcial. This gear type produces thmst loads in a direction that tends to cause the pair to separate. 

Miter gears are bevel gears with the same number of teeth in both gears, operating on shafts at right angles or at 90° as shown in Figure 57.17. 

---