Foreign Contacts

In group (a) pipe/soil potentials are evaluated. Here the explanations in the first half of Section 3.3.1 and criterion No. 1 in Table 3-1 are relevant. If the protection criterion is not fulfilled > U, the cause must be found and remedied (e.g., removing foreign contacts, repairing major holidays or increasing the protection current). 

Foreign contacts were also thriving. Representatives of the PTCh attended International Union of Pure and Applied Chemistry conferences, including the first meeting in Rome in 1920. Collaboration with European chemical societies... 

Disinfectant Formulations and Sterilization. Hundreds of appHcations covering disinfectant compositions using sodium chlorite have been described in U.S. and foreign patents. Some examples of these are as antimicrobial additives for latexes (166), marine antifouling agents (see Coatings, marine) (167,168), antimildew detergent compositions (169), toothpaste and solution compositions for prevention and treatment of periodontal oral disease (see Dentifrices) (170—172), and compositions for the disinfection of contact lenses (qv) (173). 

Contacts with other pipelines or grounds can be localized to within a few hundred meters by pipe current measurements. Contacts with foreign pipelines or cables can also be found by measuring potential at the fittings of the other line while the protection current of the cathodically protected pipeline is switched on and off. While the potential of unconnected pipelines will assume more positive values when the protection current is switched on, the cathodic current may also enter any line in contact with the cathodically protected pipeline and thus shift its potential to more negative values. Should the contacting line not be located by this method, fault location can be attempted with direct or alternating current. 

Anodic polarization exiting stray currents, contact with foreign cathodic... 

Prevention of Electrical Contact with Foreign Objects... 

The switching-off method for 7/ -free potential measurement is, according to the data in Fig. 3-5, subject to error with lead-sheathed cables. For a rough survey, measurements of potential can be used to set up and control the cathodic protection. This means that no information can be gathered on the complete corrosion protection, but only on the protection current entry and the elimination of cell activity from contacts with foreign cathodic structures. The reverse switching method in Section 3.3.1 can be used to obtain an accurate potential measurement. Rest and protection potentials for buried cables are listed in Table 13-1 as an appendix to Section 2.4. The protection potential region lies within U[[Pg.326]

---