Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Vibrational spectroscopy force field calculations

Terms representing these interactions essentially make up the difference between the traditional force fields of vibrational spectroscopy and those described here. They are therefore responsible for the fact that in many cases spectroscopic force constants cannot be transferred to the calculation of geometries and enthalpies (Section 2.3.). As an example, angle deformation potential constants derived for force fields which involve nonbonded interactions often deviate considerably from the respective spectroscopic constants (7, 7 9, 21, 22). Nonbonded interactions strongly influence molecular geometries, vibrational frequencies, and enthalpies. They are a decisive factor for the transferability of force fields between systems of different strain (Section 2.3.). [Pg.169]

The potential energy expressions used for force field calculations are all descendants of three basic types originating from vibrational spectroscopy (5) the generalized valence force field (GVFF), the central force field, and the Urey-Bradley force field. General formulations for the relative potential energy V in these three force fields are the following ... [Pg.165]

CIRDLS = infrared diode laser spectroscopy ES = electronic spectroscopy, spectra with resolved vibrational structure MW = microwave spectroscopy force field calculations denote harmonic frequencies obtained on the basis of combined analysis of electron diffraction and vibrational spectroscopy data. [Pg.789]

Force constants of have been calculated from the data in Table 2 using the general valence force field (GVFF) [148, 149] as well as the Urey-Bradley force field [80] (UBFF) although there is insufficient data to evaluate all the interaction constants since no isotopomers of Se have been measured by vibrational spectroscopy. The stretching and bond interaction force constants were reported as/r = 2.24 andf = 0.53 N cm, respectively [149]. However, because of the uncertainty regarding the Am mode of Se the published force constants [80, 148, 149] maybe unreliable. [Pg.68]

Mercaptosulfonium salts H3S2+MF6 (M = As, Sb), analogs of protonated hydrogen peroxide, have been prepared [Eq. (4.37)] and characterized by vibrational spectroscopy by Minkwitz et al.161 According to calculations (ab initio, general force field), the cation 59 has a conformation with the lone pair of H2S+ antiperiplanar to the S—H bond. [Pg.333]

An important task for theory in the quest for experimental verification of N4 is to provide spectral characteristics that allow its detection. The early computational studies focused on the use of infrared (IR) spectroscopy for the detection process. Unfortunately, due to the high symmetry of N4(7)/) (1), the IR spectrum has only one line of weak intensity [37], Still, this single transition could be used for detection pending that isotopic labeling is employed. Lee and Martin has recently published a very accurate quartic force field of 1, which has allowed the prediction of both absolute frequencies and isotopic shifts that can directly be used for assignment of experimental spectra (see Table 1.) [16]. The force field was computed at the CCSD(T)/cc-pVQZ level with additional corrections for core-correlation effects. The IR-spectrum of N4(T>2 ) (3) consists of two lines, which both have very low intensities [37], To our knowledge, high level calculations of the vibrational frequencies have so far only been performed... [Pg.433]

A molecule-independent, generalized force field for predictive calculations can be obtained by the inclusion of additional terms such as van der Waals and torsional angle interactions. This adds an additional anharmonic part to the potential (see below) but, more importantly, also leads to changes in the whole force field thus the force constants used in molecular mechanics force fields are not directly related to parameters obtained and used in spectroscopy. It is easy to understand this dissimilarity since in spectroscopy the bonding and angle bending potentials describe relatively small vibrations around an equilibrium geometry that, at least... [Pg.49]

J. M. Granadino-Rolddn, M. Femdndez-G6mez, A. Navarro U.A. Jayasooriya (2003). Phys. Chem. Chem. Phys., 5, 1760-1768. The molecular force field of 4-fluorostyrene an insight into its vibrational analysis using inelastic neutron scattering, optical spectroscopies (IR/Raman) and theoretical calculations. [Pg.388]


See other pages where Vibrational spectroscopy force field calculations is mentioned: [Pg.47]    [Pg.184]    [Pg.191]    [Pg.65]    [Pg.5]    [Pg.92]    [Pg.143]    [Pg.120]    [Pg.290]    [Pg.334]    [Pg.128]    [Pg.280]    [Pg.275]    [Pg.360]    [Pg.44]    [Pg.195]    [Pg.376]    [Pg.277]    [Pg.47]    [Pg.32]    [Pg.115]    [Pg.633]    [Pg.110]    [Pg.241]    [Pg.242]    [Pg.261]    [Pg.261]    [Pg.254]    [Pg.223]    [Pg.12]    [Pg.161]    [Pg.451]    [Pg.214]    [Pg.195]    [Pg.17]    [Pg.313]    [Pg.241]    [Pg.242]    [Pg.106]   
See also in sourсe #XX -- [ Pg.228 , Pg.242 ]




SEARCH



Field calculations

Force calculation

Force field calculations, vibrational

Force-field calculations

Forced vibrations

Vibration /vibrations spectroscopy

Vibrational calculations

Vibrational force field

© 2024 chempedia.info