Fluid displacement in the reservoir

The recovery factors for oil reservoirs mentioned in the previous section varied from 5 to 70 percent, depending on the drive meohanism. The explanation as to why the other 95 to 30 percent remains in the reservoir is not only due to the abandonment necessitated by lack of reservoir pressure or high water cuts, but also to the displacement of oil in the reservoir. 

The macroscopic sweep efficiency s the fraction of the total reservoir which is swept by water (or by gas in the case of gas cap drive). This will depend upon the reservoir quality and continuity, and the rate at which the displacement takes place. At higher rates, displacement will take place even more preferentially in the high permeability layers, and the macroscopic displacement efficiency will be reduced. 

This is why an offtake limit on the plateau production rate is often imposed, to limit the amount of by-passed oil, and increase the macroscopic sweep efficiency. 

On a microscopic scale (the inset represents about 1 - 2mm ), even in parts of the reservoir which have been swept by water, some oil remains as residual oil. The surface tension at the oil-water interface is so high that as the water attempts to displace the oil out of the pore space through the small capillaries, the continuous phase of oil breaks up, leaving small droplets of oil (snapped off, or capillary trapped oil) in the pore space. Typical residual oil saturation (S ) is in the range 10-40 % of the pore space, and is higher in tighter sands, where the capillaries are smaller. 

The microscopic displacement efficiency is the fraction of the oil which is recovered in the swept part of the reservoir. If the initial oil saturation is S i, then 

---