Feedback circuits designing voltage

As a result of the effects of nonideal structures, second-order effects in parameters, and the numerous approximations made in the derivation of the current-voltage equations, (C.27) and (C.30) can only serve as a qualitative description of the actual device each individual design must be experimentally characterized. For these reasons it is advantageous to operate the FET in the constant drain current mode in which case a suitable feedback circuit supplies the gate voltage of the same magnitude but of the opposite polarity to that produced by the electrochemical part of the device. 

What are the best guess maximum and minimum limits of the load current and are there any intermittent characteristics in its current demand such as those presented by motors, video monitors, pulsed loads, and so forth Always add 50 percent more to what is told to you since these estimates always turn out to be low. Also what are the maximum excursions in supply voltage that the designer feels that the circuit can withstand. This dictates the design approaches of the cross-regulation of the outputs, and feedback compensation in order to provide the needs of the loads. 

Fig. 11.1. Two basic types of current ampliflers. (a) Feedback picoammeter. It consists of two components, an operational amplifier (op-amp) A, and a feedback resistor 1 fb- a typical value of the feedback resistor used in STM is 10 fl. The stray capacitance Cfb is an inevitable parasitic element in the circuit. In a careful design, Cfb 0.5 pF. The input capacitance Cm is also an inevitable parasitic element in the circuit. Those parasitic capacitors, the thermal noise of the feedback resistor, and the characteristics of the op-amp are the limiting factors to the performance of the picoammeter. (b) An electrometer used as a current amplifier (the shunt current amplifier). The voltage at the input resistance is amplified by the circuit, which consists of an op-amp and a pair of resistors R, and R2. The parasitic input capacitance Cm limits the frequency response, and the Johnson noise on Rm is the major source of noise. Also, the input resistance for this arrangement is large.

Current feedback amplifiers always consist of a diamond transistor (DT) and a buffer stage internally connected. The OPA660 [42] or its replacement OPA860 [43] allows separated access to both circuit parts so that a voltage-controlled current source (OTA) at a bandwidth of 90 MHz and a buffer stage at a bandwidth of 700 MHz are available. In contrast to normal transistors the diamond transistor, whose temperature-stabile operating point is internally determined, allows four-quadrant operation. The OTA provides the required almost-ideal transistor to design an emitter-coupled oscillator. 

The inductance of the lead common to both the output and input circuits has the desirable feature of providing voltage of opposite polarity to neutralize the feedback voltage of the residual plate to control grid capacitance of the tube. It should be noted, however, that the mutual coupling from the screen lead to the input resonant circuit may be a possible source of trouble, depending on the design. 

---