Structure ester enolates

The following structure represents an intermediate formed by addition of an ester enolate ion to a second ester molecule. Identify the reactant, the leaving group, and the product. 

Due to the nonaromatic character of the oxepin system the oxepinones do not usually form stable enol structures. By O-acylation or O-alkylation, however, the enol forms can be stabilized as enol esters and ethers, respectively. A large number of substituted 1-benzoxepins have been synthesized by this route. Acetylation of l-benzoxepin-3(2//)-ones 1 and l-benzoxepin-5(2/T)-ones 3 was readily achieved with acetic anhydride in the presence of an appropriate base such as pyridine, triethylamine or sodium acetate.t5,t6 t72 176... 

Fig. 6.14. Possible transition structures for [3,3]-sigmatropic rearrangement of 2-cyclohexenyl ester enol ethers. Adapted from J. Org. Chem., 68, 572 (2003), by permission of the American Chemical Society.

Similar effects were observed in the structures of the lithium salts of ester enolates [43] studied by Seebach et al. (1985). Here too systematic differences in angles are observed compared with amide and ketone enolates, and there is a correlation between the bond angles and the difference in the two C-O bond lengths at the reaction centre for three compounds [43], consistent with incipient elimination of t-butoxide to give the ketene [44] (Ferretti et al., 1991). 

Anomeric triphenylphosphonium salts have been used as well as phenylsul-fides,but in the latter case extra stabilization is necessary (see below). Anomeric nitrosugars, which have been extensively studied in C-glycosylation reactions by Vasella, will be covered in Sect. 2.2.1 and ester enolates derived from 3-deoxy-2-ketoulosonic acids (sialic acid and KDO derivatives), which bear a structural similarity to 2-deoxy pyranosides, will be covered in Sect. 4.4. Deprotonation of anomeric phenylsulfones has been discussed in Sect. 2.1.1 and additional transformations on closely related compounds are presented in Scheme 14 [20]. Alkylation of phenylsulfone 54 with epoxide 55 provides adduct 56 which eliminates benzenesulfinic acid at room temperature to give the C(l)-alkylated glycal 57 a similar elimination is also observed with adducts derived from... 

With diketene, intermediates of type (III) were isolated and subsequently cyclized under basic conditions following step (b). In the case of 3-oxo-carboxylic acid esters or 3-acyl Meldrum s acids, cyclization step (b) immediately follows reaction step (a), if a slight excess of amine is employed (85TH1 87TH1). Note that conversion of (III) to (V) involves the (IH)-enol (Table I cf. 75BSF2731). The relatively low yield in the case of malonic acid ester, as well as the failure of the reaction with the non-enolizable diphenyl phosphinylacetic ester and cyanoacetate, points to the participation of an enol structure of (III). 

The enolate structure of 17 is deduced from the IR data of the reaction medium as a result of the presence of absorption bands at 1490 cm for the C=C bond and 1665 cm for the C=0 bond of the ester group, characteristic for an internal coordination of the enolate magnesium atom with the ester C=0 . 

Carboxylic acids can be alkylated in the a position by conversion of their salts to dianions [which actually have the enolate structures RCH=C(0 )21497] by treatment with a strong base such as lithium diisopropylamide.1498 The use of Li as the counterion is important, because it increases the solubility of the dianionic salt. The reaction has been applied1499 to primary alkyl, allylic, and benzylic halides, and to carboxylic acids of the form RCHjCOOH and RR"CHCOOH.1454 This method, which is an example of the alkylation of a dianion at its more nucleophilic position (see p. 368), is an alternative to the malonic ester synthesis (0-94) as a means of preparing carboxylic acids and has the advantage that acids of the form RR R"CCOOH can also be prepared. In a related reaction, methylated aromatic acids can be alkylated at the methyl group by a similar procedure.1500... 

Enantioselective condensation of aldehydes and enol silyl ethers is promoted by addition of chiral Lewis acids. Through coordination of aldehyde oxygen to the Lewis acids containing an Al, Eu, or Rh atom (286), the prochiral substrates are endowed with high electrophilicity and chiral environments. Although the optical yields in the early works remained poor to moderate, the use of a chiral (acyloxy)borane complex as catalyst allowed the erythro-selective condensation with high enan-tioselectivity (Scheme 119) (287). This aldol-type reaction may proceed via an extended acyclic transition state rather than a six-membered pericyclic structure (288). Not only ketone enolates but ester enolates... 

The 1,4-conjugate addition of ester enolates to a, 3-enones was first reported by Kohler in 1910,138a c as an anomalous Reformatsky reaction, but chemoselectivity was dependent on the structure of the a,(3-enone and restricted to bromozinc enolates obtained from either a-bromoisobutyrate or bromomalonate esters (Scheme 66).138d,e Further evaluation, with lithio ester enolates and lithio amide enolate additions, has resulted in identification of four factors that affect the chemoselectivity and diastereoselectivity of additions to a, 3-enones.139 These factors are (a) enolate geometry, (b) acceptor geometry, (c) steric bulk of the -substituent on the acceptor enone and (d) reaction conditions. In general, under kinetic reaction conditions (-78 °C), ( )-ester enolates afford preferential 1,2-addition products while (Z)-ester enolates afford substantial amounts of 1,4-addition products however, 1,2 to 1,4 equilibration occurs at 25 C in the presence of HMPA. The stereostructure of the 1,4-adducts is dependent on the initial enolate structure for example, with ( )-enones, (Z)-ester enolates afford anti adducts, while (E)-ester enolates afford syn adducts (Scheme 54). In contrast, amide enolates show a modest preference for anti diastereomer formation. 

In summary, a stereoselective 10-step total synthetic route to the antimalarial sesquiterpene (+)-artemisinin (1) was developed. Crucial elements of the approach included diastereoselective trimethylsilylanion addition to a,p-unsaturated aldehyde 16, and a tandem Claisen ester-enolate rearrangement-dianion alkylation to afford the diastereomerically pure erythro acid 41. Finally, acid 41 was converted in a one-pot procedure involving sequential treatment with ozone followed by wet acidic silica gel to effect a complex process of dioxetane formation, ketal deprotection, and multiple cyclization to the natural product (+)-artemisinin (1). The route was designed for the late incorporation of a carbon-14 label and the production of a variety of analogues for structure-activity-relationship (SAR) studies. We were successful in preparing two millimoles of l4C-l73 which was used for conversion to I4C-arteether for metabolism75 and mode of action studies.76,77... 

Although collision induced dissociation (CID) is a well-known method for investigating the structures of cations in the gas phase (McLafferty, 1983), it has been applied much less to anions (Bowie, 1986). Actually, in some cases CID has been used to study the fragmentation mechanisms of anions, such as the elimination of molecular hydrogen from alkoxide ions (Hayes el al., 1984) or the primary fragmentation routes of ester enolate ions (Froelicher et al., 1985). 

The chiral alcohol group in Figure 13.42 was chosen to differentiate as much as possible between the half-spaces on both sides of the enolate plane. One half-space should he left entirely unhindered while the other should be blocked as completely as possible. The reaction of the alkylating reagent then occurs preferentially, and in the ideal case exclusively, from the unhindered half-space. The stereostructures of the two ester enolates of Figure 13.42 therefore model the enolate moieties of the (early ) transition states of these alkylations. The part of the transition state structure that contains the alkylating reagent is not shown. 

Lithium ester enolates are extremely important in polymer chemistry as initiators and active centers of the anionic polymerization of acrylic and methacrylic monomers in polar solvents. Thus, HF-SCF studies, comparable to those mentioned above, were undertaken on monomeric methyl isobutyrate (MIB) enolate210,211. The overall conclusions on the aggregation and solvation trends are exactly the same, the bent rj3-0,C mode being preferred over the rj1-O planar one by ca 3.3 kcalmol-1. While the dimeric MIB enolate solvated by four molecules of THF was found to be the enthalpically most stable aggregate, the prismatic S6 unsolvated MIB hexamer was computed as the preferred structure in non-polar solvents (Scheme 55)212. In the latter case, the supplementary oxygen of the ester acting as a side-chain ligand for the lithium seems to explain this remarkable stability. 

The structure of mixed aggregates involving ester enolates is also of major interest to macromolecular chemists, since ionic additives are often introduced in the polymerization medium. The more stable arrangement between lithium 2-methoxyethoxide and MIB lithium enolate was thus calculated (at the DFT level) to be a 5 1 hexagonal complex with similar O—Li lateral coordinations212. The same team has recently extended this study to complexes formed between the same enolate in THF and a-ligands such as TMEDA, DME, 12-crown-4 and cryptand-2,1,1213. Only in the case of the latter ligand could a separate ion pair [(MIB-Li-MIB),2 THF]-, Li(2,l,l)+ be found as stable, still at the DFT level, as the THF solvated dimer [(MIB-Li)2,4 THF]. 

Ester enolates can be used as molecular models of the active centers in the anionic polymerization of acrylates and methacrylates. Thus, knowledge of the structure of these models in polar and nonpolar solvents is important for the understanding of the polymerization processes. Earlier C and Li NMR smdies by Wang and coworkers of methyl... 

The reaction of a lithium ester enolate (146) with a nitrone (147) to yield a fi-hydroxylamino acid ester (149) has been recently investigated by Domingo, Merino and coworkers, using DFT (B3LYP/6-31G ) methods, to gain insight on the molecular mechanism. The proposed transition structure (148) shown in equation 42 derives from attack of the most nucleophilic center of enolate 146 on the most electrophilic center of... 

---