Echelle image dissector

The multielement detection limits with the echelle/image dissector are comparable to, or better than, single element detection limits reported for a silicon vidicon and conventional optics. Detection limits for Cr, Cu, and Mn with the echelle/ image dissector compare favorably with single element data reported for a conventional atomic absorption instrument with a photomultiplier detector, but detection limits obtained here for Ni and Co are higher by factors of 10 or more than for the conventional instrument. The echelle/image dissector system should be adaptable to a so-called flameless atomizer and be subject to the same improvements in sensitivities and detection limits as conventional detector systems. 

The main detectors used in AES today are photomultiplier tubes (PMTs), photodiode arrays (PDAs), charge-coupled devices (CCDs), and vidicons, image dissectors, and charge-injection detectors (CIDs). An innovative CCD detector for AES has been described [147]. New developments are the array detector AES. With modem multichannel echelle spectral analysers it is possible to analyse any luminous event (flash, spark, laser-induced plasma, discharge) instantly. Considering the complexity of emission spectra, the importance of spectral resolution cannot be overemphasised. Table 8.25 shows some typical spectral emission lines of some common elements. Atomic plasma emission sources can act as chromatographic detectors, e.g. GC-AED (see Chapter 4). 

Image dissector tubes (Fig. 26) make use of an entrance aperture behind the photocathode, by which the photoelectrons stemming from different locations of the photocathode can be scanned and measured after amplification in the dynode train, as in a conventional photomultiplier. Although used in combination with an echelle spectrometer with crossed dispersion for flexible rapid sequential analyses [59], these systems have not had any commercial breakthrough. This might be due to the limited cathode dimensions but also to stability problems. 

---