Diffusivity coefficient, total

Knudsen diffusion coefficient for the test gas in a micropore. represents the total void fraction and c that part of of the void fraction... 

McKillop and associates have examined the electrophoretic separation of alkylpyridines by CZE. Separations were carried out using either 50-pm or 75-pm inner diameter capillaries, with a total length of 57 cm and a length of 50 cm from the point of injection to the detector. The run buffer was a pH 2.5 lithium phosphate buffer. Separations were achieved using an applied voltage of 15 kV. The electroosmotic flow velocity, as measured using a neutral marker, was found to be 6.398 X 10 cm s k The diffusion coefficient,... 

Cg = the concentration of the saturated solution in contact with the particles, D = a diffusion coefficient (approximated by the Hquid-phase diffusivity), M = the mass of solute transferred in time t, and S = the effective thickness of the liquid film surrounding the particles. For a batch process where the total volume H of solution is assumed to remain constant, dM = V dc and... 

In addition, it was concluded that the liquid-phase diffusion coefficient is the major factor influencing the value of the mass-transfer coefficient per unit area. Inasmuch as agitators operate poorly in gas-liquid dispersions, it is impractical to induce turbulence by mechanical means that exceeds gravitational forces. They conclude, therefore, that heat- and mass-transfer coefficients per unit area in gas dispersions are almost completely unaffected by the mechanical power dissipated in the system. Consequently, the total mass-transfer rate in agitated gas-liquid contacting is changed almost entirely in accordance with the interfacial area—a function of the power input. 

Table 1.6 Characteristic quantities to be considered for micro-reactor dimensioning and layout. Steps 1, 2, and 3 correspond to the dimensioning of the channel diameter, channel length and channel walls, respectively. Symbols appearing in these expressions not previously defined are the effective axial diffusion coefficient D, the density thermal conductivity specific heat Cp and total cross-sectional area S, of the wall material, the total process gas mass flow m, and the reactant concentration Cg [114].

The contribution to the plate height from molecular diffusion in the mobile phase arises from the natural tendency of the solute band to diffuse away from the zone center as it moves through the column [59,60,63,64]. Its value is proportional to the diffusion coefficient and the. time the sample spends in the column. Its contribution to the total plate height is given by... 

Tybsre m is the total mass of analyte collected, D the molecular diffusion coefficient, A the area of the diffusion channel, L the diffusion path length, C the analyte concentration in the air, and Tt the sampling time. In deriving equation (8.7) it was assumed t. that the sorbent is effective sink for the analyte and,... 

It should be mentioned here that a different definition of the diffusion coefficient is often used in chemical engineering problems, which is more appropriate for the description of reactant or tracer transport. It takes into account the fact that the total fluid contained in a porous substance of porosity e is reduced by this factor relative to the bulk, so that an effective diffusion coefficient D of the reactants is defined such that... 

As noted by Liu et al. [42], there is a resurgence of interest in measuring diffusion coefficients using NMR spectroscopy, particularly in complex biological fluids which contain a number of molecules having a broad range of molecular weights and concentrations. These authors demonstrated the use of two-dimensional diffusion-edited total correlation NRM spectroscopy to measure diffusion coefficients in human blood samples. 

M Lui, JK Nicholson, JA Parkinson, JC Lindon. Measurement of bimolecular diffusion coefficients in blood plasma using two-dimensional 1II-1 II diffusion-edited total-correlation NMR spectroscopy. Anal Chem 69 1504-1509, 1997. 

The diffusion coefficient (D) of ferf-butyloxycarbonyl-L-phenylalanine (Boc-Phe) was determined in a Merrifield network of polystyrene (PS) gels used as a solid phase reaction field.108 When probe molecules have multicomponents in diffusion on the measurement time scale, the total echo attenuation is given by a superposition of contributions from the individual components ... 

---