Dichloromethane ligand

Recently Desimoni et used the same bis(oxazoline) ligand in the magnesium(II) catalysed Diels-Alder reaction of the N-acyloxazolidinone depicted in Scheme 3.4. In dichloromethane a modest preference was observed for the formation of the S-enantiomer. Interestingly, upon addition of two equivalents of water, the R-enantiomer was obtained in excess. This remarkable observation was interpreted in terms of a change from tetrahedral to octahedral coordination upon the introduction of the strongly coordinating water molecules. 

Among the J ,J -DBFOX/Ph-transition(II) metal complex catalysts examined in nitrone cydoadditions, the anhydrous J ,J -DBFOX/Ph complex catalyst prepared from Ni(C104)2 or Fe(C104)2 provided equally excellent results. For example, in the presence of 10 mol% of the anhydrous nickel(II) complex catalyst R,R-DBFOX/Ph-Ni(C104)2, which was prepared in-situ from J ,J -DBFOX/Ph ligand, NiBr2, and 2 equimolar amounts of AgC104 in dichloromethane, the reaction of 3-crotonoyl-2-oxazolidinone with N-benzylidenemethylamine N-oxide at room temperature produced the 3,4-trans-isoxazolidine (63% yield) in near perfect endo selectivity (endo/exo=99 l) and enantioselectivity in favor for the 3S,4J ,5S enantiomer (>99% ee for the endo isomer. Scheme 7.21). The copper(II) perchlorate complex showed no catalytic activity, however, whereas the ytterbium(III) triflate complex led to the formation of racemic cycloadducts. 

We therefore prepared a new chiral ligand, (l ,J )-isopropylidene-2,2 -bis[4-(o-hy-droxybenzyl)oxazoline)], hereafter designated J ,J -BOX/o-HOBn. To our delight, the copper(II) complex catalyst prepared from J ,J -BOX/o-HOBn ligand and Cu(OTf)2 was quite effective (Scheme 7.45). Especially, the reaction of O-benzylhydroxylamine with l-crotonoyl-3-isopropyl-2-imidazolidinone in dichloromethane (0.15 m) at -40°C in the presence of J ,J -BOX/o-HOBn-Cu(OTf)2 (10 mol%) provided the maximum enantioselectivity of 94% ee. 

Compounds lb and 2b were the Urst fluorinated ligands tested in Mn-catalyzed alkene epoxidation [5,6]. The biphasic Uquid system perfluorooc-tane/dichloromethane led to excellent activity and enantioselectivity (90% ee) in the epoxidation of indene with oxygen and pivalaldehyde (Scheme 1, Table 1). In addition, the fluorous solution of the catalyst was reused once and showed the same activity and selectivity. This represents a considerable improvement over the behavior in the homogeneous phase, where the used catalyst was bleached and reuse was impossible. Unfortunately, indene was the only suitable substrate for this system, which failed to epoxidize other alkenes (such as styrene or 1,2-dihydronaphthalene) with high enantioselectivity. The system was also strongly dependent on the oxidant and only 71% ee was obtained in the epoxidation of indene with mCPBA at - 50 °C. 

With three sulfur atoms above and three below the equatorial plane of the molecule, 190 was expected to be a good ligand for metal ions. However, a dichloromethane solution of 190 did not extract any ions from an aqueous solutions of various metal salts (in total 23 different cations including AP+,Ba +,... 

An iron complex-catalyzed asymmetric hydrosilylation of ketones was achieved by using chiral phosphoms ligands [68]. Among various ligands, the best enantios-electivities (up to 99% ee) were obtained using a combination of Fe(OAc)2/(5,5)-Me-Duphos in THF. This hydrosilylation works smoothly in other solvents (diethylether, n-hexane, dichloromethane, and toluene), but other iron sources are not effective. Surprisingly, this Fe catalyst (45% ee) was more efficient in the asymmetric hydrosilylation of cyclohexylmethylketone, a substrate that proved to be problematic in hydrosilylations using Ru [69] or Ti [70] catalysts (43 and 23% ee, respectively). 

The addition of a further equivalent of neutral ligand to a suspension of [ AuAg (C6F5)2L J in dichloromethane leads to a colorless solution which upon addition of n-hexane precipitates complexesof the type [AgLL ][Au(C6F5)2] with L = Py, L = py or L = phen, bipy, L = PPh3. Taking into account all available data, the probable formation of these complexes is shown in the Equation 3.11 ... 

In 2001, a new chiral bis(benzothiazines) ligand was reported by Harmata et al. and successfully applied to the test reaction (Scheme 1.58). The authors studied, in particular, different reaction conditions to perform this reaction and proved that good yields and enantioselectivities were obtained in relatively nonpolar solvents, whereas the reaction remained racemic in dichloromethane... 

The intermolecular Pauson-Khand reaction of the resulting S/P-cobalt complexes with norbornadiene was studied under thermal and A -oxide activation conditions. Thus, heating the diastereomerically pure complex (R = Ph, R = Cy) with ten equivalents of norbornadiene at 50 °C in toluene afforded the corresponding exo-cyclopentenone in a quantitative yield and with an enantio-selectivity of 99% ee. Under similar conditions, the analogous trimethylsilyl complex (R = TMS, R = Cy) afforded the expected product in a high yield but with a lower enantioselectivity of 57% ee. In order to increase this enantio-selectivity, these authors performed this reaction at room temperature in dichloromethane as the solvent and in the presence of NMO, which allowed an enantioselectivity of 97% ee to be reached. These authors assumed that the thermal activation promoted the isomerisation of the S/P ligand leading to a nonstereoselective process. 

---