Diatomic molecules, atomization

It is hopefully clear by now that even the simplest diatomic molecule-atomic collision partner limit presents us with a number of possible types of contributing collisions to the collision-induced intersystem-crossing rates. It should be emphasized that a truly quantitative treatment would have to even include any hyperfine energies as the mixing angles (3.3c) can be greatly affected by zeroth order hyperfine shifts that are comparable to... 

In the case the vibration diatomic molecules atoms can oscillate just in the direction of connection covalent) binding atoms. In the case of molecules consisting of several atoms (N atoms) the description of the assembly oscillations, even in harmonic appa-oximation, is significantly more complicated. In principle, each atom in the structure molecule can execute, independently of the other atoms of the same molecule, the three-way oscillation linear independent (after three axes orthogonal coordinate attached each of atoms). 

Although a diatomic molecule can produce only one vibration, this number increases with the number of atoms making up the molecule. For a molecule of N atoms, 3N-6 vibrations are possible. That corresponds to 3N degrees of freedom from which are subtracted 3 translational movements and 3 rotational movements for the overall molecule for which the energy is not quantified and corresponds to thermal energy. In reality, this number is most often reduced because of symmetry. Additionally, for a vibration to be active in the infrared, it must be accompanied by a variation in the molecule s dipole moment. 

Even with these complications due to anliannonicity, tlie vibrating diatomic molecule is a relatively simple mechanical system. In polyatomics, the problem is fiindamentally more complicated with the presence of more than two atoms. The anliannonicity leads to many extremely interestmg effects in tlie internal molecular motion, including the possibility of chaotic dynamics. 

The interaction energy can be written as an expansion employing Wigner rotation matrices and spherical hamionics of the angles [28, 130], As a simple example, the interaction between an atom and a diatomic molecule can be expanded hr Legendre polynomials as... 

Consider the collision of an atom (denoted A) with a diatomic molecule (denoted BC), with motion of the atoms constrained to occur along a line. In this case there are two important degrees of freedom, the distance R between the atom and the centre of mass of the diatomic, and the diatomic intemuclear distance r. The Flamiltonian in tenns of these coordinates is given by ... 

Kaye J A and Kuppermann A 1988 Mass effect in quantum-mechanical collision-induced dissociation in collinear reactive atom diatomic molecule collisions Chem. Phys. 125 279-91... 

The reaction of an atom with a diatomic molecule is the prototype of a chemical reaction. As the dynamics of a number of atom-diatom reactions are being understood in detail, attention is now being turned to the study of the dynamics of reactions involving larger molecules. The reaction of Cl atoms with small aliphatic hydrocarbons is an example of the type of polyatomic reactions which are now being studied [M, 72, 73]. 

These electronic energies dependence on the positions of the atomic centres cause them to be referred to as electronic energy surfaces such as that depicted below in figure B3.T1 for a diatomic molecule. For nonlinear polyatomic molecules having atoms, the energy surfaces depend on 3N - 6 internal coordinates and thus can be very difficult to visualize. In figure B3.T2, a slice tln-oiigh such a surface is shown as a fimction of two of the 3N - 6 internal coordinates. 

Miller W H 1969 Coupled equations and the minimum principle for collisions of an atom and a diatomic molecule, including rearrangements J. Chem. Phys. 50 407... 

The simplest condensed phase VER system is a dilute solution of a diatomic in an atomic (e.g. Ar or Xe) liquid or crystal. Other simple systems include neat diatomic liquids or crystals, or a diatomic molecule bound to a surface. A major step up in complexity occurs with poly atomics, with several vibrations on the same molecule. This feature guarantees enonnous qualitative differences between diatomic and polyatomic VER, and casts doubt on the likelihood of understanding poly atomics by studying diatomics alone. 

A simple example would be in a study of a diatomic molecule that in a Hartree-Fock calculation has a bonded cr orbital as the highest occupied MO (HOMO) and a a lowest unoccupied MO (LUMO). A CASSCF calculation would then use the two a electrons and set up four CSFs with single and double excitations from the HOMO into the a orbital. This allows the bond dissociation to be described correctly, with different amounts of the neutral atoms, ion pair, and bonded pair controlled by the Cl coefficients, with the optimal shapes of the orbitals also being found. For more complicated systems... 

As our first model problem, we take the motion of a diatomic molecule under an external force field. For simplicity, it is assumed that (i) the motion is pla nar, (ii) the two atoms have equal mass m = 1, and (iii) the chemical bond is modeled by a stiff harmonic spring with equilibrium length ro = 1. Denoting the positions of the two atoms hy e 71, i = 1,2, the corresponding Hamiltonian function is of type... 

A more useful quantity for comparison with experiment is the heat of formation, which is defined as the enthalpy change when one mole of a compound is formed from its constituent elements in their standard states. The heat of formation can thus be calculated by subtracting the heats of atomisation of the elements and the atomic ionisation energies from the total energy. Unfortunately, ab initio calculations that do not include electron correlation (which we will discuss in Chapter 3) provide uniformly poor estimates of heats of formation w ith errors in bond dissociation energies of 25-40 kcal/mol, even at the Hartree-Fock limit for diatomic molecules. 

The fact that the separated-atom and united-atom limits involve several crossings in the OCD can be used to explain barriers in the potential energy curves of such diatomic molecules which occur at short intemuclear distances. It should be noted that the Silicon... 

This difference is shown in the next illustration which presents the qualitative form of a potential curve for a diatomic molecule for both a molecular mechanics method (like AMBER) or a semi-empirical method (like AMI). At large internuclear distances, the differences between the two methods are obvious. With AMI, the molecule properly dissociates into atoms, while the AMBERpoten-tial continues to rise. However, in explorations of the potential curve only around the minimum, results from the two methods might be rather similar. Indeed, it is quite possible that AMBER will give more accurate structural results than AMI. This is due to the closer link between experimental data and computed results of molecular mechanics calculations. 

The theory of molecular symmetry provides a satisfying and unifying thread which extends throughout spectroscopy and valence theory. Although it is possible to understand atoms and diatomic molecules without this theory, when it comes to understanding, say, spectroscopic selection rules in polyatomic molecules, molecular symmetry presents a small barrier which must be surmounted. However, for those not needing to progress so far this chapter may be bypassed without too much hindrance. 

Equation (6.8), to (d /dx)g. Figure 6.1 shows how the magnitude /r of the dipole moment varies with intemuclear distance in a typical heteronuclear diatomic molecule. Obviously, /r 0 when r 0 and the nuclei coalesce. For neutral diatomics, /r 0 when r qg because the molecule dissociates into neutral atoms. Therefore, between r = 0 and r = oo there must be a maximum value of /r. Figure 6.1 has been drawn with this maximum at r < Tg, giving a negative slope d/r/dr at r. If the maximum were at r > Tg there would be a positive slope at r. It is possible that the maximum is at r, in which case d/r/dr = 0 at Tg and the Av = transitions, although allowed, would have zero intensity. 

Figure 7.14 Molecular orbital energy level diagram for first-row homonuclear diatomic molecules. The 2p, 2py, 2p atomic orbitals are degenerate in an atom and have been separated for convenience. (In O2 and F2 the order of

Some heteronuclear diatomic molecules, such as nitric oxide (NO), carbon monoxide (CO) and the short-lived CN molecule, contain atoms which are sufficiently similar that the MOs resemble quite closely those of homonuclear diatomics. In nitric oxide the 15 electrons can be fed into MOs, in the order relevant to O2 and F2, to give the ground configuration... 

For atoms, electronic states may be classified and selection rules specified entirely by use of the quantum numbers L, S and J. In diatomic molecules the quantum numbers A, S and Q are not quite sufficient. We must also use one (for heteronuclear) or two (for homonuclear) symmetry properties of the electronic wave function ij/. ... 

In the case of atoms, deriving states from configurations, in the Russell-Saunders approximation (Section 7.1.2.3), simply involved juggling with the available quantum numbers. In diatomic molecules we have seen already that some symmetry properties must be included, in addition to the available quantum numbers, in a discussion of selection rules. 

In the case of atoms (Section 7.1) a sufficient number of quantum numbers is available for us to be able to express electronic selection rules entirely in terms of these quantum numbers. For diatomic molecules (Section 7.2.3) we require, in addition to the quantum numbers available, one or, for homonuclear diatomics, two symmetry properties (-F, — and g, u) of the electronic wave function to obtain selection rules. 

For the orbital parts of the electronic wave functions of two electronic states the selection rules depend entirely on symmetry properties. [In fact, the electronic selection rules can also be obtained, from symmetry arguments only, for diatomic molecules and atoms, using the (or and Kf point groups, respectively but it is more... 

An Xc2 excimer laser has been made to operate in this way, but of much greater importance are the noble gas halide lasers. These halides also have repulsive ground states and bound excited states they are examples of exciplexes. An exciplex is a complex consisting, in a diatomic molecule, of two different atoms, which is stable in an excited electronic state but dissociates readily in the ground state. In spite of this clear distinction between an excimer and an exciplex it is now common for all such lasers to be called excimer lasers. 

All heteronuclear diatomic molecules, in their ground electronic state, dissociate into neutral atoms, however strongly polar they may be. The simple explanation for this is that dissociation into a positive and a negative ion is much less likely because of the attractive force between the ions even at a relatively large separation. The highly polar Nal molecule is no exception. The lowest energy dissociation process is... 

---