Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Cylinders storing

Design and manage cylinder stores in accordance with suppliers recommendations. [Pg.272]

The preferred solution is CO2 recycling at a pressure of about 40-50 bar, slightly below the typical pressure inside CO2 cylinders stored at ambient temperature. Eluent recycling and condensation at this pressure requires cooling uhlities for a temperature range of 0-5 °C. Under these condihons the solute-eluent separation... [Pg.258]

The basic unit of mass in the SI system is the kilogram (Table 1-6). The kilogram is defined as the mass of a platinum-iridium cylinder stored in a vault in Sevres, near Paris, France. A 1-lb object has a mass of 0.4536 kg. The basic mass unit in the earlier metric system was the gram. A U.S. five-cent coin (a nickel ) has a mass of about 5 g. [Pg.18]

The breadboard system was also tested by using metal hydride as the H2 source (Figure 5.26). The H2 supply system was composed of 4 metal hydride cylinders. Each cylinder contained 58 kg Ti-series AB2-type metal hydride, and the total mass of each cylinder was 89 kg. Since the metal hydride could store 1.9% of H2 by weight, each cylinder stored about 1.1 kg of H2. The... [Pg.219]

Are compressed gas cylinders stored in areas protected from external heat sources such as flame... [Pg.182]

Are cylinders stored or transported in a manner to prevent them from creating a hazard by tipping,... [Pg.182]

The international prototype is a platinum-iridium cylinder stored in a vault of the International Bureau of Weights and Measures in Sfevres near Paris, France. [Pg.470]

In the United States, acetylene cylinders stored inside a building at user locations must be limited to a total capacity of 2500 ft (70.8 m ) of gas, exclusive of cylinders in use or attached for use. Quantities exceeding this total must be stored in a special building or in a separate room as required by NFPA 51 [4]. [Pg.228]

Cylinders may be stored in the open, but must be protected against extremes of weather and from the dampness of the ground to prevent rusting. During the summer, cylinders stored in the open should be shaded against the continuous direct rays of the sun in those localities where extreme temperatures prevail. [Pg.341]

Protect cylinders stored outdoors from the ground to prevent bottom corrosion. Where extreme temperatures prevail, protect cylinders from the direct rays of the sun. [Pg.71]

APC (Denmark), which uses Hydrogenics stacks, has launched a fuel cell backup power system for data centres. The InfraStruXure , with rack mounted integrated fuel cell system, provides up to 3 x 10 kW of power. The hydrogen fuel is bottled and stored in T-shaped gas cylinders, with each cylinder storing enough fuel for 79 minutes per lOkW stack. The system is available now from a range of distributors such as UPS Systems (UK). [Pg.85]

Are oxygen and fuel gas cylinders stored a minimum of 20 feet apart ... [Pg.301]

Are propane cylinders stored and used only outside of buildings ... [Pg.304]

Are compressed gas cylinders stored in areas which are protected from external heat sources such as flame impingement, intense radiant heat, electric arcs, or high-temperature hnes... [Pg.133]


See other pages where Cylinders storing is mentioned: [Pg.316]    [Pg.39]    [Pg.39]    [Pg.118]    [Pg.39]    [Pg.39]    [Pg.118]    [Pg.250]    [Pg.190]    [Pg.158]    [Pg.195]    [Pg.124]    [Pg.419]    [Pg.67]    [Pg.363]    [Pg.228]    [Pg.217]    [Pg.258]    [Pg.304]   
See also in sourсe #XX -- [ Pg.48 ]




SEARCH



Storing

© 2024 chempedia.info