Cyclooctene, reaction with dibromocarbene

Introduction of the allene structure into cycloalkanes such as in 1,2-cyclononadiene (727) provides another approach to chiral cycloalkenes of sufficient enantiomeric stability. Although 127 has to be classified as an axial chiral compound like other C2-allenes it is included in this survey because of its obvious relation to ( )-cyclooctene as also can be seen from chemical correlations vide infra). Racemic 127 was resolved either through diastereomeric platinum complexes 143) or by ring enlargement via the dibromocarbene adduct 128 of optically active (J3)-cyclooctene (see 4.2) with methyllithium 143) — a method already used for the preparation of racemic 127. The first method afforded a product of 44 % enantiomeric purity whereas 127 obtained from ( )-cyclooctene had a rotation [a]D of 170-175°. The chirality of 127 was established by correlation with (+)(S)-( )-cyclooctene which in a stereoselective reaction with dibromocarbene afforded (—)-dibromo-trans-bicyclo[6.1 0]nonane 128) 144). Its absolute stereochemistry was determined by the Thyvoet-method as (1R, 87 ) and served as a key intermediate for the correlation with 727 ring expansion induced... 

Dibromocarbene undergoes addition to alkenes in a stereospecific manner. The sole case of nonstereospecific dibromocyclopropanation using bromoform/base/phase-transfer catalyst concerns ( )-cyclooctene, and is explained by isomerization of this cycloalkene caused by reversible addition of tribromomethyl or ethoxide anion the latter is formed from the ethanol present in bromoform (see also ref 2 and Houben-Weyl, Vol. El 9b, p 1617 for stereomutation in the reactions of dibromocarbene, generated from organomercury reagents, with low-active alkenes, see Section 1.2.1.4.3.1.5.1. and Vol. E19b, pp 1615 1616). 

A mixture of 0.20 mol of the adduct from cyclooctene and dibromocarbene (note 1) and 250 ml of dry diethyl ether was cooled to -65°C. A solution of 0.23 mol of ethyllithium (note 2) in 200 ml of diethyl ether (see Chapter II, Exp. 1) was added in 15 min with cooling between -60 and -50°C. The reaction was very exothermic (note 3). After the addition the cooling bath was removed and the temperature was allowed to rise to about -10°C and the reaction mixture was poured into 200 ml of ice-water. The aqueous layer was extracted twice with diethyl ether. After drying, the solvent was removed in a water-pump vacuum and the remaining liquid was distilled through a 40-cm Vigreux column. 1,2-Cyclononadiene, b.p. 62°C/22 mmHg, 1.5059, was obtained in 86 yield. 

---

See also in sourсe #XX -- [ ]

---