Cycloaddition reactions dioxetane intermediate

Cycloaddition reactions can occur with retention of configuration in the pseudoexcitation band (Sect 1.1) whereas [2jt H-2jtJ reactions are symmetry-forbidden in the delocalization band. Experimental evidence is available for the stereospecific [2-1-2] cycloaddition reactions between A and olefins with retention of configuration (Scheme 14) [82]. A perepoxide intermediate was reported to be trapped in the epoxide form [83] in the reaction of adamantylideneadamantane with singlet oxygen affording dioxetane derivatives [84]. 

The reaction mechanism for the aerobic oxidation of the pz to seco-pz can be attributed to a formal 2 + 2 cycloaddition of singlet oxygen to one of the pyrrole rings, followed by cleavage (retro 2 + 2) of the dioxetane intermediate to produce the corresponding seco-pz (160). This mechanism is shown in Scheme 29 for an unsymmetrical bis(dimethylamino)pz. Further photophysical studies show that the full reaction mechanism of the photoperoxidation involves attack on the reactant by singlet oxygen that has been sensitized by the triplet state of the product, 159. As a consequence, the kinetics of the process is shown to be autocatalytic where the reactant is removed at a rate that increases with the amount of product formed. 

Since [4 + 2]cycloaddition and ene reactions are generally assumed to proceed in a concerted manner via isopolar activated complexes, they should exhibit virtually the same small, often negligible, response to changes in solvent polarity. This is what, in fact, has been found cf. for example [138, 682, 683]. However, two-step [2 + 2]-cycloaddition reactions of singlet oxygen to suitably substituted electron-rich alkenes proceed via dipolar activated complexes to zwitterionic intermediates (1,4-dipoles or perepoxides). In this case, the relative amounts of 1,2-dioxetane and allylic hydroperoxides or e do-peroxides should vary markedly with solvent polarity if two or even all three of the reaction pathways shown in Eq. (5-145) are operative [681, 683, 684]. 

The many variables involved in the autoxidation of fatty acid moieties make it difficult to generalize the results of a particular laboratory experiment to real-world situations. Reports of many reactions do not explain the source of the energy that drives them. Nevertheless, results tend to be accepted in those instances in which the products of the reaction have a lower total energy state than the starting reagents. In the case of the autoxidation of methyl sorbate, for example (Fig. 4.1), the reaction products are consistent with those that would be obtained with a thermodynamically unlikely dioxetane intermediate (1,2). Hydroperoxides and cyclic peroxides (not shown) are also products of this reaction (2). These products are hypothesized to arise through 1,2 addition, 1,3 addition (the ene reaction) and 1,4 cycloaddition respectively. 

---