Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Counterbore cutters

Counterbore cutters are made from high-speed steel and may have parallel or taper shanks. [Pg.127]

A spotface cutter. Fig. 8.15, is used to provide a flat and square seating for a screw, bolt or nut on the surface of the workpiece, usually on the surface of a rough casting which would not otherwise provide a sufficiently accurate seating. The spotface is similar to a counterbore cutter, but has teeth on the end only. It will cut to only a very limited depth and caimot be used to counterbore. Counterbore cutters, on the other hand, can be used to spotface. [Pg.127]

Counterbore cutters, on the other hand, can be used to spotface. [Pg.124]

Twist drill Spade drill Trepanning cutter Center drill Combination drill Countersink Counterbore... [Pg.468]

See other pages where Counterbore cutters is mentioned: [Pg.127]    [Pg.127]    [Pg.123]    [Pg.123]    [Pg.127]    [Pg.127]    [Pg.123]    [Pg.123]   
See also in sourсe #XX -- [ Pg.123 , Pg.123 ]



SEARCH



Counterbore

Cutter

© 2024 chempedia.info