Cooling discharge

The cooled discharge mass is loaded out of the reactor into the bin and transported into the baking department. 

The practice of cooling discharge tubes in liquid air allowed some reduction in the Doppler width, but this technique was not always fully exploited since it was common to use high current densities in order to obtain a bright atomic spectrum. A considerable advance wras made after the discovery of deuterium in 1932, since the Doppler width of these lines compared with those of the light isotope is smaller by the factor (see Fig. 3). 

This anomalous shift of the 42P term was not confirmed by later work of Herzberg [61]. In these experiments the line was excited in a liquid-nitrogen cooled discharge, and analysed spectroscopically with a powerful grating. The resolution was slightly inferior to that of Series, but the interval (3)—(4) could be measured with comparable precision. No disagreement with the radiation theory was found. 

Charge Heat Reaction Cool Discharge Flush Dry Prep Down... 

Benzylthiouronium salts. Add 0 5 g. of sulphanilic acid to 10 ml. of water and 5 ml. of 10% NaOH solution, zndgently warm the shaken mixture until a clear solution is obtained. Cool, add 1 drop of phenol-phthalein solution, and then add dilute HCl dropwise with shaking until the pink colour is just discharged. Now add very dilute NaOH solution until the pink colour yt/rZ returns. Cool and add with shaking a solution of 0-5 g. of benzylthiouronium chloride in 5 ml. of water. The thiouronium salt rapidly separates filter at the pump, wash with water, drain and recrystallise from ethanol. Colourless crystals, m.p. 185°. (M.ps., p. 548.)... 

Cuprous bromide. The solid salt may be prepared by dissolving 150 g. of copper sulphate crystals and 87 5 g. of sodium bromide dihydrate in 500 ml. of warm water, and then adding 38 g. of powdered sodium sulphite over a period of 5-10 minutes to the stirred solution. If the blue colour is not completely discharged, a little more sodium sulphite should be added. The mixture is then cooled, the precipitate is collected in a Buchner funnel, washed twice with water containing a little dissolved sulphurous acid, pressed with a glass stopper to remove most of the liquid, and then dried in an evaporating dish or in an air oven at 100 120°. The yield is about 80 g. 

Place 20 g. of Orange II (Section IV,79) in a 600 ml. beaker and dissolve it in 250 ml. of water at 40-50°. Add, with stirring, 24-25 g. of sodium hyposulphite (Na SjO ) this discharges the colour and yields a pink or cream-coloured, finely-divided precipitate of a-amino-p-naphthol (compare Section IV,76). Heat the mixture nearly to boiling until it commences to froth considerably, then cool to 25° in ice, filter on a... 

These ion lasers are very inefficient, partly because energy is required first to ionize the atom and then to produce the population inversion. This inefficiency leads to a serious problem of heat dissipation, which is partly solved by using a plasma tube, in which a low-voltage high-current discharge is created in the Ar or Kr gas, made from beryllium oxide, BeO, which is an efficient heat conductor. Water cooling of the tube is also necessary. 

The lime, cooled somewhat by the entering air in the lower parts of the shaft kiln, is discharged intermittently and slaked to calcium hydroxide with... 

---