Cooling Degradability

Prepared feeds are marketed in various forms from very fine particles through cmmbles, flakes, and pellets. Pelleted rations may be hard, semimoist, or moist. Hard pellets typically contain less than 10% water and can be stored under cool, dry conditions for at least 90 days without deterioration of quahty. Semimoist pellets are chemically stabilized to protect them from degradation and mold if they are properly stored, while moist pellets must be frozen if they are not used immediately after manufacture. Moist feeds are produced in machines similar to sausage grinders. 

Secondary bonds are considerably weaker than the primary covalent bonds. When a linear or branched polymer is heated, the dissociation energies of the secondary bonds are exceeded long before the primary covalent bonds are broken, freeing up the individual chains to flow under stress. When the material is cooled, the secondary bonds reform. Thus, linear and branched polymers are generally thermoplastic. On the other hand, cross-links contain primary covalent bonds like those that bond the atoms in the main chains. When a cross-linked polymer is heated sufficiently, these primary covalent bonds fail randomly, and the material degrades. Therefore, cross-linked polymers are thermosets. There are a few exceptions such as cellulose and polyacrylonitrile. Though linear, these polymers are not thermoplastic because the extensive secondary bonds make up for in quantity what they lack in quahty. 

Fungi. Two forms of fungi commonly encountered are molds (filamentous forms) and yeasts (unicellular forms). Molds can be quite troublesome, causing white rot or brown rot of the cooling tower wood, depending on whether they are cellulolytic (attack cellulose) or lignin degrading. Yeasts are also cellulolytic. They can produce slime in abundant amounts and preferentially colonize wood surfaces. 

Higher temperatures result in permanent degradation. The amount of this irreversible loss in mechanical properties depends upon moisture content, heating medium, temperature, exposure period, and, to some extent, species. The effects of these factors on modulus of mpture, modulus of elasticity, and work to maximum load are illustrated in Figures 6—9 (6). The effects may be less severe for commercial lumber than for clear wood heated in air (Fig. 10). The permanent property losses shown are based on tests conducted after specimens were cooled to - 24° C and conditioned to a moisture content of... 

When antifreeze becomes unsuitable for use, either because of depletion of inhibitors, presence of corrosion products or corrosive ions, or degradation of the fluid, recycling and reuse of the antifreeze, rather than disposal, may be considered. Although ethylene glycol is readily biodegraded in typical municipal waste treatment faciHties, antifreeze disposal becomes problematic because the coolant may contain hazardous quantities of heavy metals picked up from the cooling system. Recycling may be economically preferred over coolant disposal and reduces the concern for environmental impact. 

Other factors which can affect impact behaviour are fabrication defects such as internal voids, inclusions and additives such as pigments, all of which can cause stress concentrations within the material. In addition, internal welds caused by the fusion of partially cooled melt fronts usually turn out to be areas of weakness. The environment may also affect impact behaviour. Plastics exposed to sunlight and weathering for prolonged periods tend to become embrittled due to degradation. Alternatively if the plastic is in the vicinity of a fluid which attacks it, then the crack initiation energy may be reduced. Some plastics are affected by very simple fluids e.g. domestic heating oils act as plasticisers for polyethylene. The effect which water can have on the impact behaviour of nylon is also spectacular as illustrated in Fig. 2.80. 

---