Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Conclusions on Injection Molding

The injection system offers various advantages over the usual molding system  [Pg.132]

FIGURE 5.13 Torque-time curves obtained with the same rubber sample using the oscillating die rheometer (ODR) and the moving die rheometer (MDR). [Pg.133]

Sadr-Bazaz A., R. Granger, and J.M. Vergnaud. 1984. Calculation of profiles of temperature and state of cure developed within the rubber mass in injection molding [Pg.133]

Ferradou C., B. Rochette, and J.M. Vergnaud. 1985. Effect of a variation in kinetic parameters (rate constant, activation energy) on the vulcanization of rubber sheets in injection molding process. J. Appl. Polym. Sci. 30 2663-74. [Pg.133]

See other pages where Conclusions on Injection Molding is mentioned: [Pg.132]   


SEARCH



Conclusion

© 2024 chempedia.info