Compression theory

Figure 7.12 Excess chemical potential of the hard-sphere fluid as a function of density. The open and filled circles correspond to the predictions of the primitive quasi-chemical theory and the self-consistent molecular field theory, respectively. The solid and dashed lines are the scaled-particle (Percus-Yevick compressibility) theory and the Carnahan-Starling equation of state, respectively (Pratt and Ashbaugh, 2003).

Subsequent calculations by Moliner and Williams109 at the HF/6-31G, the HF/6-31G, the B3LYP/6-31G and the B3LYP/6-31G levels of theory tested the compression theory in an elegant study. They calculated the energies and transition... 

The CS pressures are close to the machine calculations in the fluid phase, and are bracketed by the pressures from the virial and compressibility equations using the PY approximation. Computer simulations show a fluid-solid phase transition tiiat is not reproduced by any of these equations of state. The theory has been extended to mixtures of hard spheres with additive diameters by Lebowitz [35], Lebowitz and Rowlinson [35], and Baxter [36]. 

The osmotic coefficients from the HNC approximation were calculated from the virial and compressibility equations the discrepancy between ([ly and ((ij is a measure of the accuracy of the approximation. The osmotic coefficients calculated via the energy equation in the MS approximation are comparable in accuracy to the HNC approximation for low valence electrolytes. Figure A2.3.15 shows deviations from the Debye-Htickel limiting law for the energy and osmotic coefficient of a 2-2 RPM electrolyte according to several theories. 

If the finite size of the system is ignored (after all, A is probably 10 or greater), the compressibility is essentially infinite at the critical point, and then so are the fluctuations. In reality, however, the compressibility diverges more sharply than classical theory allows (the exponent y is significantly greater dian 1), and thus so do the fluctuations. 

Microscopic theory yields an exact relation between the integral of the radial distribution function g(r) and the compressibility... 

The separation of two surfaces in contact is resisted by adhesive forces. As the nonnal force is decreased, the contact regions pass from conditions of compressive to tensile stress. As revealed by JKR theory, surface tension alone is sufficient to ensure that there is a finite contact area between the two at zero nonnal force. One contribution to adhesion is the work that must be done to increase surface area during separation. If the surfaces have undergone plastic defonnation, the contact area will be even greater at zero nonnal force than predicted by JKR theory. In reality, continued plastic defonnation can occur during separation and also contributes to adhesive work. 

The strength of laminates is usually predicted from a combination of laminated plate theory and a failure criterion for the individual larnina. A general treatment of composite failure criteria is beyond the scope of the present discussion. Broadly, however, composite failure criteria are of two types noninteractive, such as maximum stress or maximum strain, in which the lamina is taken to fail when a critical value of stress or strain is reached parallel or transverse to the fibers in tension, compression, or shear or interactive, such as the Tsai-Hill or Tsai-Wu (1,7) type, in which failure is taken to be when some combination of stresses occurs. Generally, the ply materials do not have the same strengths in tension and compression, so that five-ply strengths must be deterrnined ... 

Theory of Compression In any continuous compression process the relation of absolute pressure p to volume V is expressed by the formula... 

---