Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Compression molding versus injection

Silverman characterized flexural creep resistance at 120°C (33) and room temperature impact resistance (34) for test specimens from injection-molded composites of chopped fibers versus machined specimens from compression molded continuous long GFR polypropylene sheets. His concepts of glass fiber reinforcement in stampable composites tend to mirror many of the attributes related to megacoupling of short GFRP. [Pg.467]

Table 7-23. Cost Comparison of Resin-Transfer Molding versus SMC Compression and Injection Molding... Table 7-23. Cost Comparison of Resin-Transfer Molding versus SMC Compression and Injection Molding...
Figure 1 Volume resistivity versus volume fraction of aluminum flakes in various polymers. Open symbols represent injection-molded composites with 50 1 aspect ratio flakes. Filled symbols represent compression-molded composites 16.7 1 aspect ratio flakes. ( , ) polypropylene, (A) polycarbonate, (O) ABS. From Li, L. and Chung, D.D.L. (1994) Composites, 25(3). Figure 1 Volume resistivity versus volume fraction of aluminum flakes in various polymers. Open symbols represent injection-molded composites with 50 1 aspect ratio flakes. Filled symbols represent compression-molded composites 16.7 1 aspect ratio flakes. ( , ) polypropylene, (A) polycarbonate, (O) ABS. From Li, L. and Chung, D.D.L. (1994) Composites, 25(3).
See other pages where Compression molding versus injection is mentioned: [Pg.782]    [Pg.337]    [Pg.15]    [Pg.586]    [Pg.81]    [Pg.87]    [Pg.8]    [Pg.423]    [Pg.469]    [Pg.6208]    [Pg.459]    [Pg.382]    [Pg.99]    [Pg.13]    [Pg.724]   


SEARCH



Compression molding

Injection compression

Molding injection-compression

© 2024 chempedia.info