Compression molding nickel

Compression molded (150°C for 3 minutes press chilled with cold water immediately thereafter) samples of poly(trans-l,4-hexadiene) (14) and poly(5-methyl-l,4-hexadiene) were examined with a General Electric (XRD-3) X-ray unit. Transmission Laue X-ray photographs were taken using nickel filtered copper X-radiation. Samples were stretched to four times of their original lengths to obtain oriented fibers. The fiber patterns were obtained in a flat plate film holder with the specimen to film distance standardized at 5 centimeters. X-ray diffraction patterns were similarly obtained for the hydrogenated sample of poly(5-methyl-l,4-hexadiene). 

A suitable sample for ASAXS compression-molding the nickel disc. 

S.3.4. INEOS Electrolyzers. BMEOS FM21-SP monopolar electrolyzer (Fig. 5.29) uses stamped electrodes. The anode is a 2-mm thick titanium panel between compression-molded joints of a special cross-linked EPDM elastomer. The cathode is a 2-mm thick nickel panel between compression molded EPDM joints. 

Nickel-cadmium button cells and batteries usually have electrodes made from pressed plates. The active materials are compressed in molds into disks or plates, and the electrodes are assembled in a sandwich configuration, as shown in Fig. 28.3. 

---