Chemical composition factors affecting

The final properties of every polymeric material are determined by its chemical composition and its physical structure. Whereas chemical composition mainly affects its chemical aging processes, physical structure affects both chemical and physical aging processes. Other factors, such as catalytically active contamination, can affect all aging processes. Chemical and physical aging processes also influence each other, e.g., post-crystallization can reduce oxygen diffusion and thus affect oxidation and vice versa [19]. 

While several factors determine ESP collection efficiency, ESP size is most important. Size determines treatment time, the longer a particle spends in the ESP, the greater its chance of being collected. Maximizing electric field strength will maximize ESP collection efficiency. Collection efficiency is also affected to some extent by dust resistivity, gas temperature, chemical composition (of the dust and the gas), and particle size distribution. 

The chemical composition of the SEI formed on carbonaceous anodes is, in general, similar to that formed on metallic lithium or inert electrodes. However some differences are expected as a result of the variety of chemical compositions and morphologies of carbon surfaces, each of which can affect the i() value for the various reduction reactions differently. Another factor, when dealing with graphite, is solvent co-intercalation. Assuming Li2C03 to be a major SEI building material, the thickness of the SEI was estimated to be about 45 A [711. 

The origins and composition of plastics wastes and factors affecting their recycling are discussed. Partieular attention is paid to chemical recycling and incineration, with and without energy recovery, and a number of developments in chemical recycling techniques are examined. 19 refs. 

Cement properties are affected by a number of factors. Some are determined by the manufacturer, for example the chemical composition of the cement components. Others are under the clinician s control. These include the powder/liquid ratio of the cement mix and the temperature of the surgery. Increase in either of these variables accelerates the reaction and affects properties. 

Several factors such as Cl concentration, water/rock ratio and temperature are important in controlling the chemical composition of the hydrothermal solution interacted with the rocks. For example, water/rock ratio affects the alteration mineralogy (Mottl and Holland, 1978 Seyfried and Mottl, 1982 Shikazono, 1984). For example, at low water/rock ratio, epidote is stable, while chlorite at high water/rock ratio (Shikazono, 1984 Shikazono and Kawahata, 1987). 

The minimum thickness specification for an FML top liner covered with a layer of soil is 0.75 mm for an FML without a soil cover layer, the specification is 1.14 mm. An FML in a composite bottom liner system must be at least 0.75 mm thick. Even though these FML thicknesses meet U.S. EPA specifications, 0.75mm is not a suitable thickness for all FML materials. In fact, most FML materials installed at landfills are in the range of 1.50-2.50 mm in thickness. Other key factors affecting the selection of FML materials include chemical compatibility with waste leachate, aging and durability characteristics, stress and strain characteristics, ease of installation, and water vapor/ chemical permeation. 

Nonstoichiometry of the oxides can be due to a number of reasons, such as hydration,159 incomplete oxidation,158 and the generation of defects at interfaces.157 An important factor affecting the chemical composition of the oxides is the incorporation of electrolyte species into the growing alumina. There have even been suggestions to use this for impurity doping of oxides and modifying their properties.161 Various kinds of anion distributions and mechanisms of anion incorporation and their influence on oxide properties have been reported. The problems attracting attention are ... 

Factors affecting the size of the mesoglobules include polymer concentration, i.e. the size increases with solution concentration and, more importantly, heating rate (Fig. 34). Thus, a fast increase in temperature (nonequilibrium heating) leads to mesoglobules of smaller size than those formed upon slow heating through the sample LCST [ 141 -145,147]. The chemical composition of... 

In addition to the gasification agent (air, oxygen, or steam) and the gasifier operating temperature and pressure, other factors affect the chemical composition, heating value,... 

---