Butadiene-pentadiene

The alkoxymercuration of conjugated dienes is more complex since these compounds are less reactive than simple alkenes and the products often react further to afford dimercurated products whose regio- or stereo-chemistry is strongly affected by the initial product. For example, 1,3-butadiene, 1,3-pentadiene, 2,3-dimethyl-1,3-butadiene and 1,3-cyclohexadiene react with meicuiy(II) acetate in methanol to produce 1,2-adducts (equation 265).443-446 These adducts sometimes rearrange with time.446 1,3-Butadiene reacts further to afford primarily the meso adduct of double 1,2-additions.447 Surprisingly, little additional work has been reported on reactions of conjugated dienes. 

Cycloaddition of phosphorus(III) halides to 1,3-dienes (such as 1,3-butadiene, 1,3-pentadiene, and 2-methyl-1,3-butadiene) followed by solvolysis is known to produce cyclic unsaturated phosphorus heterocycles, i.e., 2- and 3-phospholene 1-oxide derivatives 94 and 95, respectively, depending on the chloride and bromide of the phosphorus halides (Fig. 6) [34-36]. 

As was found for the polymerization of styrene, CpTiCT/M AO and similar half-sandwich titanocenes are active catalysts for the polymerization of conjugated 1,3 dienes (Table XX) (275). Butadiene, 1,3-pentadiene, 2-methyl-l,3-pentadiene, and 2,3-dimethylbutadiene yield polymers with different cis-1,4, trans-1,4, and 1,2 structures, depending on the polymerization temperature. A change in the stereospecificity as a function of polymerization temperature was observed by Ricci et al. (276). At 20°C, polypen-tadiene with mainly ds-1,4 structures was obtained, whereas at -20°C a crystalline, 1,2- syndiotactic polymer was produced. This temperature effect is attributed to a change in the mode of coordination of the monomer to the metallocene, which is mainly cis-rf at 20°C and trans-rj2 at -20°C. 

As found for the polymerization of styrene, CpTiCl3/MAO and similar half-sandwich titanocenes are active catalysts for the polymerization of conjugated 1,3-dienes (Table 25) [218], Butadiene, 1,3-pentadiene, 2-methyl-l,3-pentadiene and 2,3-dimethylbutadiene yield polymers with different... 

Photolysis of Os3(CO)i2 in the presence of a diene (1,3-butadiene, 1,3-pentadiene, 1,3-cyclooctadiene, or 1,3-cyclohexadiene) gives the mononuclear diene complexes Os(CO)3()]" -diene). The 1,3-cyclooctadiene complex OsCl2(COD)(PEtPh2)2 was prepared by the reduction of [OsCle] " in the presence of the diene followed by treatment withPEtPh2. 

Mixed cyclopentadienyl-diene titanium complexes, Cp TiX(diene)(X = Cl, Br, I), have been prepared in 30-60% yield by the stoichiometric reaction of CpTiXs with (2-butene-l,4-diyl)magnesium derivatives or by the reduction of CpTiXs with RMgX (R = i-Pr, f-Bu, Et X = Cl, Br, I) in the presence of conjugated dienes, as shown in Scheme 4. The butadiene, 1,3-pentadiene, and 1,4-diphenylbutadiene complexes of Cp TiX exhibit a unique prone (endo) conformation (13), while the isoprene, 2,3-dimethylbutadiene, and 2,3-diphenylbutadiene complexes prefer the supine (exo) conformation (14). Reduction of Cp TiX(diene) with RMgX or Mg gives a low-valent species, which catalyzes a highly selective (>99%) tail-to-head linear dimerization of isoprene and 2,3-dunethylbutadiene. " ... 

Zirconocene complexes (with s-cis geometry) of isoprene, 2,3-dimethylbutadiene, and 3-methyI-I,3-pentadiene are reported to give exclusively 1 1 addition with carbonyl substrates even if these are used in excess and the reaction temperature is fairly high (ca. 100 C). On the contrary, zirconocene complexes of 5-ci5-butadiene, 1,3-pentadiene, and 2,4-hexadiene ca, 1 1 mixture of the s-cis and s-trans isomers) easily accept (equation 53) 2 equiv. of either butanal or 3-pentanone, at low temperature ca. 30 C) in high yields (95%). This can be exploited for the stepwise insertion of two different electrophiles... 

---