Burner diaphragm type

Because indirect-heat calciners frequently require close-fitting gas seals, it is customaiy to support aU parts on a selFcontained frame, for sizes up to approximately 2 m in diameter. The furnace can employ elec tric heating elements or oil and/or gas burners as the heat source for the process. The hardware would be zoned down the length of the furnace to match the heat requirements of the process. Process control is normaUy by shell temperature, measured by thermocouples or radiation pyrometers. When a special gas atmosphere must be maintained inside the cyhnder, positive rotaiy gas se s, with one or more pressurized and purged annular chambers, are employed. The diaphragm-type seal ABB Raymond (Bartlett-Snow TM) is suitable for pressures up to 5 cm of water, with no detectable leakage. 

The operation of a control valve involves an air supply that positions its movable part (i.e. plug, ball, or vane) relative to the stationary seat of the valve. A valve actuator accurately locates the valve plug in a position determined by the pneumatic control signal and operates to move the valve to either fully open or fully closed positions. The actuators may be either piston or diaphragm types. Air-to-open valves require air to open and therefore automatically close in the event of fail closure. They are therefore used on fuel lines to furnaces. Air-to-close valves fail to open on a loss of air pressure and are used on air lines into fuel burners. In general, fail-to-open and fail-to-close valves operate when the supplied air pressure drops below a minimum value. 

---

See also in sourсe #XX -- [ , , ]

---